Could you do a video on where to find the best deals on front end Isuzu parts and then a whole video of replacing all the front parts that would cause wobble
up my way this is the way i do it. the cotter pin is rusted and seized in the end so i cut the cotter pin some and hammer a socket and zip it off. take the nut off flip it upside down and put a few threads on and hit it with a sledge hammer a few times to remove. repeat on the other side and then replace the entire tiered ends and tube. Have to love Vermont and all the Salt
I'm getting some front end vibration and certain speeds. King pin change helped a lot. And I adjusted the worm gear on the steering. I want to check the toe on the front axel. What is the recommended alignment? Toe in ? If so how much?
Check and see if you have power at the socket. If you don’t check fuses. If there is power at the fuse trace wiring and check for power every 6 inches till you find a break in the wire. I hope that helps.
Thanks for sharing there aren’t a lot of useful videos on maintenance on these NPRs
Your videos are great. Have definitely helped out his new NPR owner right here 😎👍
Good job señor
Could you do a video on where to find the best deals on front end Isuzu parts and then a whole video of replacing all the front parts that would cause wobble
up my way this is the way i do it. the cotter pin is rusted and seized in the end so i cut the cotter pin some and hammer a socket and zip it off. take the nut off flip it upside down and put a few threads on and hit it with a sledge hammer a few times to remove. repeat on the other side and then replace the entire tiered ends and tube. Have to love Vermont and all the Salt
I’m from Tennessee so rust usually isn’t an issue. Either method your best friend is a BFH
I'm getting some front end vibration and certain speeds. King pin change helped a lot. And I adjusted the worm gear on the steering. I want to check the toe on the front axel. What is the recommended alignment? Toe in ? If so how much?
What’s the torque for the castle nuts on tie rod ends
Does the same go for the drag link as far as the twisting motion?
are these tire rods enough to make this truck shake like crazy when they go bad? almost feels like the damn tire is about to go flying
Can you show how to replace the rear taillight bulbs?
czcams.com/video/FAjrMv1dd6Q/video.html
I have those roof lights on top of my npr. I changed the bulbs on them but they’re still not working. Any idea what could be the problem.. thanks.
Check and see if you have power at the socket. If you don’t check fuses. If there is power at the fuse trace wiring and check for power every 6 inches till you find a break in the wire. I hope that helps.