Impeller Position # Run Out Check # Prepare for # Bending Shaft #

[@rahulgharat873]

What is the limit?

[@capebongo6622]

According to you measurements what were you specific checking, and what was the reading there

[@blueoceanengineering]

Check for value run out of shaft from 0 degree until 360 degree

[@mohamedbenarba4703]

1dexiem

[@blueoceanengineering]

Range accepted 0 - ( +/-) 0.1 mm

[@feridmesiyev3028]

which diameter shaft is valid for?

[@kalvinsujiwo78]

​@@feridmesiyev3028All marked parts of this shaft diameter are valid