Elica built in extractor - fitting

If you've found this video you're probably already struggling with fitting an Elica extractor, and haven't had much luck with the instructions (which are rubbish). We needed to drop our extractor a few mm to repair some plaster...and it took 3 days and A LOT of swearing to get it back in place.
I made this video to remind us of the system if we ever needed to move it again, because I'd have killed for something like this at around day 1.5. Sorry for the shaky camera work, but I hope its useful.
PS the model is a Skydome, but I'm pretty sure the Hilight uses a similar system
PPS although this extractor is a royal PIA to fit, it does work really well and is very quiet, so hang in there.
PPS GOOD LUCK!

[@markusgeltenpoth4291]

Elica mount is a big sh.... , Our didn't fit because the max height of the fittings is 4cm and with a support frame you have at least 5cm

[@teamonster6030]

I know, it's terrible isn't it! We made up a frame using 20mm square steel tubes from a DIY store (that the hood fixings would fit over), which we attached to a stronger frame above using long bolts.