I had the same problem. I cleaned the carburetor, added new fuel with some sea foam fuel additive. It ran rough for a minute and then ran fine afterwards. No issues since.
Make sure the gasoline turn valve arrow is pointing to on. After your go-kart motor starts don't turn the choke off and let motor run a couple minutes to warm it up then turn choke off. Hope this helps you buddy 👍
Hey! If you are still having the same problem when you pull the starter and after it turns on leave then choke in the position towards you. Then let it run until you hear a stuttering sound almost. Where the engine sounds different than normal then put the choke back.
You need to clean the jet. Mine was having the same problem and the jet needed cleaned. On the carburetor there is a black screw. On the screw head there is a cap. Remove the cap and unscrew. Then pull the black jet up out of the carburetor. Take some compressed air and blow out the jet and the hole that the jet is in. This should let the gas’s flow through the jet and into your engine.
Here’s the answer. I actually have one of these myself. But the reason it stalls when you move the choke is because you must move it slowly or I WILL stall the engine. See if this helps.
When you when you turn the choke on, you have to turn the choke on yeah like you did but like one second later, you have to put it like back on the run so you can drive it and then it won’t stall
I had the same problem. I cleaned the carburetor, added new fuel with some sea foam fuel additive. It ran rough for a minute and then ran fine afterwards. No issues since.
thanks
What a sweet kid hope it gets fixed
Did u ever get it fixed ?
Make sure the gasoline turn valve arrow is pointing to on.
After your go-kart motor starts don't turn the choke off and let motor run a couple minutes to warm it up then turn choke off.
Hope this helps you buddy 👍
what is the choke
Did you turn the choke off?
Your float in the carburetor, it might have some stuff in it
My does that too, you just have to let it run on choke for like 5 mins
what is the choke?
it starts engine
When you get them, they start up as first pool but in a year so they take like three or so so you should give it some gas if it’s stalling on you
You do not need to give it throttle the run, but it would be better if you did try it
When you start it don’t push the choke all the way up push it not even half way. Hope it helps
Hey! If you are still having the same problem when you pull the starter and after it turns on leave then choke in the position towards you. Then let it run until you hear a stuttering sound almost. Where the engine sounds different than normal then put the choke back.
try to be quick and hurry with putting the choke back in place thats what it was for me on mine at times
I had the same problem too I don’t know for sure if this will work but you should try adding fuel and replacing the oil
You need to clean the jet. Mine was having the same problem and the jet needed cleaned. On the carburetor there is a black screw. On the screw head there is a cap. Remove the cap and unscrew. Then pull the black jet up out of the carburetor. Take some compressed air and blow out the jet and the hole that the jet is in. This should let the gas’s flow through the jet and into your engine.
Here’s the answer. I actually have one of these myself. But the reason it stalls when you move the choke is because you must move it slowly or I WILL stall the engine. See if this helps.
It’s not that I have a common GK 200 it’s like the same set up, but I move it really fast and it still doesn’t stall
When you when you turn the choke on, you have to turn the choke on yeah like you did but like one second later, you have to put it like back on the run so you can drive it and then it won’t stall
This fixed mine turn the choke of slowly or leave it on partly then turn it off
Sometimes you just have to give it throttle to get them warmed up. They don't like to run when there cold
turn off the choke after it starts
My friend had the same problem we kept putting the gas switch back and forth and it worked
Try leaving the choke on a little longer and give it some gas and then after warms up a little bit turn the choke off
I did that to mine didn’t work going to try and clean the carburetor next
@@pedrocabrera3355did u find the problem 😢
tht wrks
I'm having the same issue, I even put a different carburetor on it that I know for sure was running fine and still stalling and will not accelerate
Try putting a little bit of gas in a carburetor not that much and then crank it over and it should stay on. That’s what I did for my predator go kart.
Turn carburetor back half a turn. Float is sticking
When you start it you need to turn on the choke and when it starts turn of the choke
Not true
@@Bobgyatt420 umm how so you tell him then
Hit the gass😂
Same problem
Hello there did he ever get his go-kart fixed?
Turn choke OFF after starting it
Adjust the cable
You need a new centrifugal clutch
Otherwise, your float in the carburetor is bad and you have to get a new one or just buy a new carburetor
You have to turn the choke off I’m a micanic even tho I’m 12 my 20 year old friend hired me
Top speed???
Give it gas
Clean carb maybe
egomaniac I just had the same problem
It might be the clutch you need a new clutch
rev it at a cirtin rpm
Clean the carburetor
You need to let it idle for longer so you can ride it without it stalling or you need a new battery
de cus themoresbocen
i could not understand wut the kid sed
You need to get a new spark plug
Go see my CZcams channel and tell all your friends to go see my CZcams channel
I don’t have the go kart anymore because the engine blow up it is the junkyard getting a new golf cart 2024.
pisdnst
Same
You do not need to give it throttle the run, but it would be better if you did try it
When you get them, they start up as first pool but in a year so they take like three or so so you should give it some gas if it’s stalling on you
Lady you need to just stop with your nonsense opinions 🤣🤣☠️