Mayflower Party Balloon Basics Mothers Day Double Flower Power

Sdílet
Vložit
  • čas přidán 29. 03. 2021
  • 1. Helium inflate a balloon of your choice, tie to a ribbon, and attach to a balloon weight.
    Note: We recommend using one of Anagram’s OrbzTM, Jumbos, or a large shape for balloon upgrade designs.
    2. Create two 3-inch, five balloon clusters by following the steps below:
    A. Air inflate two 5-inch latex balloons to 3-inches (three pumps) and tie the necks together to make a duplet. Then, Make a second duplet.
    B. Next, inflate one 5-inch balloon to 3-inches, and tie it into one of your duplets making a three-balloon cluster. Then, twist the duplet and the three-balloon cluster together to make a five-balloon cluster.
    C. Repeat the above steps to make a second five-balloon cluster.
    3. Create two 1-inch duplets for the center of your flowers by following the steps below:
    A. Air inflate two 5-inch latex balloons to 1-inches (one pump) and tie the necks together to make a duplet.
    B. Repeat the above step again to create a second 1-inch duplet.
    4. Wrap one 1-inch duplet into the center of your flowers. This should force the five “petals” in your flower to lay flat.
    Want a higher retail? Create a matching base to tie your upgraded balloon into by following the steps below:
    A. Create one 2-inch quad by inflating all four balloons in the cluster with two pumps.
    B. Create one 4-inch quad by inflating all four balloons in the cluster with four pumps.
    C. Stack the two clusters together, with the larger cluster on the bottom. Wrap a 160 or 260 scrap through the two clusters in figure out to hold them together and tie a balloon weight into the bottom, creating weighted base for your upgraded balloon.
    D. Add a 9-inch or 14-inch pre-inflate to the top of your weighted balloon base by following the steps below:
    I. Remove the cup attached to the valve of the pre-inflate balloon.
    II. Using the valve of the pre-inflate balloon, pull the pre-inflate into the top center of your balloon base, and wrap in the pre-inflate valve around the top cluster, in a figure eight.
  • Jak na to + styl

Komentáře • 7

  • @lydiapetra1211
    @lydiapetra1211 Před dnem

    Thanks so very much...they are very beautiful ❤

  • @alallen2767
    @alallen2767 Před 2 lety

    thanks for that

  • @judynajar3678
    @judynajar3678 Před 2 lety +1

    Love it can you tell me where you got the hand pump please

  • @sherrycloninger9984
    @sherrycloninger9984 Před rokem

    What inflated balloon bags do You use for travel to job?

    • @Mayflower_Party
      @Mayflower_Party  Před rokem

      We have these balloon transport bags for sale - www.mayflowerdistributing.com/38-x-58-balloon-transport-bags