iPhone 7 Plus NAND - error 9 repair - reball only
Vložit
- čas přidán 11. 09. 2024
- Here we have an iPhone 7 Plus with NAND error 9, stuk in recovery mode. Just reball the NAND and job is done
Some of the tools and supplies i use all time
- Sugon T26 soldering station with JBC C210-018, C210-002 and C210-020 tips
- Gordak 952-A (I'm using this only for it's soldering iron)
- 8858 Hot Air Station (no name)
- Seek Compact XR Thermal Camera
- Sunshine DT-17N Multimeter
- HY3005D Power Supply (very old)
- Kingbo RMA 218 Flux
- Baku BK-227 Flux
- Cynel Soldering Wire 0.5mm and 0.7mm
- Mechanic XGS40 158C Solder Paste
- Relife RL-404 138C Solder Paste
You just used a same NAND bc your NAND was just pseudo soldered? Should I buy a NAND programmer if I use a new NAND? There is no pre-programmed NAND?
Hello,
I used the same nand because the phone was dropped and nand was pseudo soldered. If you want to do this job and swap the nand you need a programmer and you need to be able to read the syscfg from old nand (you need the serial number, bt and wifi adress - these can be unbind, and few more things). There's no pre-programmed nand.
@@PhoneRepairRO Thanks for your answer.
Now I know I cannot handle this at my home😢.
Good luck good job bro
Thank you
Nice work. Just a reflow will work?
Thank you,
Do not try to do a reflow on NAND! Has underfill under the IC. Better to take out the NAND, measure all the pads if are ok / connected - if they are, either one of the pads were disconected form NAND or you have a bad NAND
@@PhoneRepairRO thanks bro for reply :)
Sir i want to learn from plzz reply
Kon sa problam er h JC
Magiko
oooooh my god🎉
Programar kyu nhi dikhaya
I didn't used any programmer. NAND was ok, the problem was that client droped the phone and one pad was pseudo soldered.