SUR-RON WIRING HARNESS EXPLAINED | SURRON DIY BUILD FROM SCRATCH
Vložit
- čas přidán 2. 01. 2024
- Describing all wiring harness connections for the Surron light bee. This will be part of my upcoming full build video - building a 25kW, 80v Surron from scratch. Note I am using the EBMX X-9000 controller, so some connections are different than from stock.
- Auta a dopravní prostředky
Hey man THANK YOU for this video. I am going in blind trying to repair someone's SurRon X that had no throttle response. Found a couple sheared wires on a mystery connector by the motor and hey guess what: Hall Effect Sensor connector. Much appreciated!
Great to hear!
Omg amazing vid this helps my horn problem a lot! Thank you dude!
EDIT: I also found your review on Ali rn. Great job!
Thanks very much. I'm currently editing the full Surron build video, it should be published in a couple weeks.
@@CoolWatts Can't wait to see it!
Thanks had the key and headlight mixed up on accident this helped!
This helped a lot man I really appreciate it
Awesome, thanks!
Really helpful video
how great is this 😍
Thanks! Glad it helped 😁
Dude.. I love you.
Great video! Really helped me with my edirt bike build!
Awesome! Thanks
@@CoolWattsYou're the only guy that I have found that did this! I'm actually trying to figure out how to get a dirt bike sproket on. Do you have any tips on that?
thanks you this helped alot
Great video btw
Is there away to extend the plugs that goes to the controller?
Thank you..
Where did you get the frame??not available in Scotland
AliExpress, all links are in pinned comment in my full build video
Hello,
maybe you could help me.
I want to install a new taillight, it has 5 cables, 2 is for signals, 1 positive, 1 negative and 1 for the brake light.
the signals I don't care about, the positive and negative is obvious, where do I need to add or to weld the brake light for it work when I'm pushing the brake levers?
Hey coolwatts! I was hoping you could help me. So I’m using all surron wiring for a non surron build. And had a question.
The “battery in” connector the small grey one. Is that connector the equivalent of positive and ground ring terminals to give the harness power?
Hi, yes, that is battery voltage in. 60v, 72v, 80v, etc.
@@CoolWatts you just saved me so much time wondering why my harness wasn’t receiving power lol. Thank you and your finished build looks awesome!
Does this still have the green loop to cut to derestrict the bike? by the top of the battery
I didn't see it on the new harness I got, purchased from Ali 12-2023.
The sleeve that covers all the cables looks tighter and made of different material then the harness that comes on a brand new bike, I have ordered the same harness as shown in this video, but I am concerned it will restrict my bikes top speed again
@@shawsie9462 if so, you just cut the wire again or connect a clamp with wires cut.