Program and Install Your Orbit Water Timer

Sdílet
Vložit
  • čas přidán 12. 09. 2024
  • This video will show you how to program and mount your Orbit hose end water timer.

Komentáře • 10

  • @Lorelcom
    @Lorelcom Před 2 lety +2

    Thanks so much for this! Neither the written instructions or the other videos actually show in any detail how to install the timer. Also, I'm going to use your idea of using a couple feet of hose to move the whole timer away from the main spigot.

  • @SJtoobsox
    @SJtoobsox Před 8 lety +1

    Best to add a copper splitter to hose bib, then attach Orbit manifold to either side of splitter. Hook hose up directly to copper splitter and you get the full use of your hose, rather than the pressure reduced stream.

  • @Swanky95472
    @Swanky95472 Před 9 lety +1

    does station 1 stand for the middle outlet? and the station 2 for the right outlet???

  • @JoanneInVirginia
    @JoanneInVirginia Před 9 lety

    Adam, if you turn on the manual value and turn it off again, does water spurt out of station 1 and or station 2, like it's purging water from the timer? Thanks.

  • @jross9800
    @jross9800 Před 6 lety

    Can you program it to water the lawn say every 6 hours or every 5 hour or is one day the minimum?

  • @bethsanpei9609
    @bethsanpei9609 Před 7 lety

    I have 55psi at the spigot. I have 6 pop ups on each station. When I install the timer the pops raise about 1/4" with hardly any water
    coming out. When I install the line directly to the spigot the pop ups work just fine. Whats the problem?

    • @diver01alan
      @diver01alan Před 7 lety

      Not enough PSI to run water through 6 pop ups. Split the pop ups into smaller groups. Hope this helped.

  • @anthonys5170
    @anthonys5170 Před 5 lety

    It automatically detects the rain right?

  • @jross9800
    @jross9800 Před 6 lety

    Can you program it to water the lawn say every 6 hours or every 5 hours or is one day the minimum?