i wish you would have shown the rest of the repair. excellent content that many people want to see. i repaired one myself not knowing what i was doing, and it came out pretty good
hello again sir, finally i will try to rewire my throttle body . can i ask you what kind of wires should i use ? (i am newbie) thanks for your time , keep good work :)
@@nemzrepairs i read in a post , black is 18 gauge and all the others 20 gauge . cause i dont know from wires , awg is the correct type ? thanks again you are a very fast replier :)
I had been looking for detailed videos like this one ! Thanks a lot!
i wish you would have shown the rest of the repair. excellent content that many people want to see. i repaired one myself not knowing what i was doing, and it came out pretty good
Excellent video, thank you.
Well done .one cuestion pin # 6 are connected with the swich wires i mean continuited
Hello, how were you able to remove the large plastic gear on the cable entry?
Thanks bro!
nice work G
Thanks 💯
How did you disconnect the electrical cable, I can't find the connection to separate it from the harness
Wondering too
hello again sir, finally i will try to rewire my throttle body . can i ask you what kind of wires should i use ? (i am newbie) thanks for your time , keep good work :)
Use same gauge as the ones in throttle
@@nemzrepairs i read in a post , black is 18 gauge and all the others 20 gauge . cause i dont know from wires , awg is the correct type ? thanks again you are a very fast replier :)
Nice work mate . Can i ask you what type of connector will you use and how can i find it . I would like to do the same on mine throttle body. Thanks.
I used a Bosch DT from Amazon
@@nemzrepairs Thank you sir , you are amazing . Can i have any serial,link ?
@@athanasiosbellos3367 amzn.to/40i9CZS
You change both sides (male-female) the connectors ? In throttle body and main wirring harness?
@@athanasiosbellos3367 yes the engine harness was in bits too
hellowe my brother where you living
Ireland
where did you find the eight pin connector to replace? I'm not getting
Amazon bro
How you remove that wheel with teeth?
I didn’t remove the wheel you just have to solder under it skilfully try it it’s but if a pain
nice man i will do the same on mine🦾