ENGINE RUNNING RICH?

Sdílet
Vložit

Komentáře • 33

  • @Dogpool
    @Dogpool Před 5 měsíci +16

    The two most common reasons I have found in my experience you left out. Number 1 I have seen most of is stuck open purge control valve. And also worn out spark plugs not burning all the fuel. I have also seen cars with both a map sensor and a mass airflow, I’m pretty sure. I can’t remember what car that was on.

    • @williamfoster5861
      @williamfoster5861 Před 3 měsíci

      My Chevy 400 was rich and it was worn spark plugs and a sticking choke

  • @markjacobsen3128
    @markjacobsen3128 Před 7 měsíci +1

    Thank you, Your Knowledge of Automobiles, and components is amazing hope you are a millionaire, and thanks for your videos, finally a person that is very smart! and Honest...

  • @Gneeznow
    @Gneeznow Před 8 měsíci +2

    Very helpful thank you, I've had this problem with a Seat Ibiza, I ended up replacing the fuel filter and fuel pump because of idle issues, but I believe it's the oxygen sensor (lambda sensor) that is causing the the running rich issue. Those oxygen sensors aren't cheap!

  • @muddrock
    @muddrock Před 4 měsíci +2

    thanks, this is helpful

  • @mytek998
    @mytek998 Před 20 dny

    This is very helpful. Thanks a lot!

  • @senbin
    @senbin Před 6 měsíci

    Awesome thank you

  • @jassihra8566
    @jassihra8566 Před 8 měsíci

    Hi,
    I enjoy your videos they are very good.
    I have a 2019 Ford Transit 350 2 litre diesel UK model (I live in the UK)
    I have a single radiator fan with 2 speeds; High Speed and Low Speed.
    When I turn my AC on, my Van no longer uses the Low Speed fan, it ONLY uses the high speed fan in 30 second cycles, and then turn off, and then again repeats the cycles. My van never use to use the High speed Fan when using the AC; it would only use low speed van. My van is not overheating at all, nor does the AC NOT work; it blows freezing cold air, as it always did, and there is no engine performance issue.
    I have gone to 3 different mechanics and they have all used their fancy scan tools, and they cannot find ANY fault codes on my van or see any abnormal values, when testing on Live View.
    How do I go about resolving this issue ? Have you got any tips for me on this issue, or direction for what I can do next ?
    please do let me know
    Thank youuu !

  • @The-Prottotype
    @The-Prottotype Před 7 měsíci +1

    been having rough starts on my Dacia Sandero and incorrect coolant temp reading ... i've read almost everywhere that it is a bad thermostat but decided to change coolant temp sensor anyway ... spent 3€ on the new sensor and now the car starts like new

  • @sulltanarif1
    @sulltanarif1 Před měsícem

    Hello sir..why my car spark plugs get black ?I have a rattling and engine knocking around and why when I'm accelerating on 120kmph and the engine stall to lower rpm..but the engine doesn't shut off..can I know why?

  • @whitewalker9622
    @whitewalker9622 Před 2 měsíci

    Hi! I have -128mA b1s1(upstream o2)and 10 kpa intake manifold absolute pressure, and it´s stuck at these values. Anyone have any idea of what is at fault?

  • @minhtrivo6922
    @minhtrivo6922 Před 8 měsíci +1

    Thank you for this , ive been trying to troubleshoot for a while this solved my problem thanks ! I appreciate your hard work 😊

  • @matt7iron
    @matt7iron Před 8 měsíci +1

    Hey bub, I have a yr 2000 Accord ulev-4 and I changed my spark plugs and now I'm getting nothing but static from my radio, I looked for any Ground wire by the battery and nothing, what happened bro.

    • @4G12
      @4G12 Před 8 měsíci

      Maybe unsuitable spark plugs? Resistor spark plugs are practically universal for EFI engines.

    • @Top5AutoRepairs
      @Top5AutoRepairs  Před 8 měsíci

      Check for loose spark plug wires. Change spark plugs and use oem.

  • @daisyirimagha3882
    @daisyirimagha3882 Před 8 měsíci +1

    Hello Bob, I have a 2009 Corolla the check engine light came on and shows a p0013 code I tried swapping the cam actuator but the code still remains. Please what may be the cause. Thanks

    • @Top5AutoRepairs
      @Top5AutoRepairs  Před 8 měsíci +2

      Check for clogged or faulty oil control valve

    • @two4u443
      @two4u443 Před 8 měsíci

      ​@@Top5AutoRepairsYAY!!!🥳🎈🎉♥️ I just found your channel. Please Sir...desperately need help. My 2008 Kia Optima just started this...not wanting to start after filling up at gas station. It takes several tries. I had Purge Valve replaced, both O2 Sensors replaced, Canister Vent Valve replaced and cleaned Throttle Body. So aggravating. Any suggestions?? Thanks for any help.😊

    • @daisyirimagha3882
      @daisyirimagha3882 Před 8 měsíci

      @@Top5AutoRepairs thanks sir will check and get back to you

    • @daisyirimagha3882
      @daisyirimagha3882 Před 8 měsíci

      @@Top5AutoRepairs I swapped my oil control valve with a friend's and the check engine light was still there. I swapped both intake and exhaust

    • @Top5AutoRepairs
      @Top5AutoRepairs  Před 8 měsíci +1

      Charcoal canister might be saturated with fuel

  • @javihernandez16mx3
    @javihernandez16mx3 Před 20 dny

    This guy forgot code p2188 and he also said a car that has a map sensor doesn't have a mass air flow he's wrong a mazdaspeed 3 has a map sensor and a mass air flow

    • @sav7123
      @sav7123 Před 14 dny

      I have this code on my mazdaspeed, I have changed everything except the MAP sensor and I’m still running rich

    • @javihernandez16mx3
      @javihernandez16mx3 Před 14 dny

      @sav7123 what kind of mass air flow did u. Install also check pressure sensor for the gas

    • @sav7123
      @sav7123 Před 14 dny

      @@javihernandez16mx3 I have a denso MAF sensor. I also changed the pressure sensor on the fuel rail and the injectors.

    • @javihernandez16mx3
      @javihernandez16mx3 Před 14 dny

      @sav7123 do a leak down test your rings might be shot

  • @alexcolima7894
    @alexcolima7894 Před 8 měsíci +1

    My Honda feels forced, it will gradually go up in speed if I press the gas slowly but say I need to pick up speed quickly and press down on the gas all the way the rpm will shoot up but the engine won’t accelerate. Any tips on where to start? No engine light tho

    • @Cook2430
      @Cook2430 Před měsícem

      Transmission slip possibly.