The Last Run That Destroyed The Engine of Traxxas Revo 3.3

The factory setting on a low speed needle was wrong from the very beginning on Traxxas Revo 3.3. As a result, this made engine sound horrible.
Make sure to always double check both low speed as well as high speed needles before breaking in the nitro engine to avoid causing any damage.
This wrong setting caused a permanent damage to nitro engine.

[@johnclemans7802]

Need to preheat the engine with a hair dryer or heat gun. Run an OS LC 4 glow plug and VP Racing 30% nitro. Change to lower gears. See break-in procedures on line. Need to richen the car setting too.
Change out the stock tuned pipe for the low end, midrange Traxxas pipe.
Takes practice and patience. Don't give up.

[@vernonfarabee]

I didn't see no smoke from the exhaust pipe

[@ironhead320]

Too lean hear that high pitch

[@GiantsFan1734]

Was this the first run? Truck looked brand new

[@rccarsisland]

This was like the third run

[@GiantsFan1734]

Don’t know if you moved on from the engine, but always go with a rich setting for the break in but obviously not too rich to where it’s not hot enough to burn fuel. I’ve had good results with the traxxas break in method, go through all 5 tanks and the tune it on the 6th tank for performance but once again never too lean.

[@Revelation1177]

?