FAQ #1 LATEX MOLDS & MOLD RELEASE AGENT
Vložit
- čas přidán 22. 08. 2024
- This is the very first video in the FAQ series! To start off this video series we answer the question "What mold release agent do you use for latex molds?".
If you enjoyed this video, please like and share. :)
Hit the notification bell if you would like to receive notifications of new videos. :)
Any comments, please post below. :)
Music: www.purple-pla...
Check out the Amazon Storefront for materials used on the channel: www.amazon.co....
Subscribe at: / dramamask2011
Website: www.dramamaskev...
Facebook: / dramamaskevolution
Twitter: / dramamask
Instagram: / dramamask1973
Ebay: www.ebay.co.uk/...
Etsy: www.etsy.com/u...
For molding and casting enthusiasts, please visit: www.diymolds.com
Other videos:
Make A CONCRETE SLAB/PAVER: • Make A CONCRETE SLAB/P...
Make A CONCRETE LEAF: • Make A CONCRETE LEAF
Casting With POLYCRAFT SG2000 Polyurethane Resin: • Casting With POLYCRAFT...
RUSTY METALLIC PAINT FX On CONCRETE SKULL: • RUSTY METALLIC PAINT F...
Easy OLDE WORLDE PAINT WASH Effect For Concrete Ornaments: • EASY OLDE WORLDE PAINT...
CONCRETE CASTING | Demolding & Troubleshooting Concrete Mix: • CONCRETE CASTING | Dem...
Yeah i have used just soap water, but mostly alc plus castor oil. Hows thangs going Drama!!!
Cheers Frank! All good here and I hope all is good at your end! :)
Think you for another video about molds and mold making.
Thank you Joelle! :)
Many, Many thanks for your video, keep the videos going. Many thanks, Lyla
Thank you Lyla! :)
The thanks are all mine
OK THANKS SO VERY, VERY MUCH. LYLA
Cheers Lyla. :)
Use surgical spirits mixed with castor oil only need few drops mix together think its 10-1 put in spray
Thank you Terry! Do you know the exact recipe? If so, I will pin it in the comments. :)
I forgot to ad I like your nw look,short hair and a shave!
I'm going bald now, so thought it best to have short hair! :D An annual shave too. :D :D :D
How about mold release on original plaster piece before painting latex?
I prefer to latex on a clean dry surface to get as much detail as possible.
HELLO AGAIN,THIS IS LYLA CAN I ASK HOW I DUPLICATE A DIPPED LATEX MOULD I HAVE PURCHASED ?, DO I BRUSH MY LATEX INTO THE ORIGINAL MOULD ?. MANY THANKS AGAIN.
No, that doesn't sound like a good idea! You might want to make a cast and then make a mold from the cast.
Getting ready to sculpt a 4 foot alien and mold it be my first we'll see how it turns out mite be a disaster haha
I'm looking forward to seeing it, Vick! I am sure you will do a great job as you always do! :)
@@dramamask let's hope brother it could be a huge turd lol
@@MONSTERMISFITS Like my seagull! :D
@@dramamask haha i thought it looked good.
@@MONSTERMISFITS You liked it because you thought it was a zombie-pigeon! :D :D :D