Plasma XR Mods, Water Table Storage and Filtration Series 1of2
Vložit
- čas přidán 10. 07. 2022
- A few Mods that make draining/cleaning your table a bit easier.
Summary:
This Overview shows the major components and system function, Follow up Video will go into detail on the Speed Control device.
Mods Covered:
-Splash Guard
-Holding Tanks
-Pond Filter
-Pump
-Speed Controller
-Enlarged Drains
-Drain Manifold
Outer Dimensions of Holding Tanks:
12"w x 12"h x 60"l
Pitch of base plate: 2" Drop.
** Remember, The low point of the first tank must be equal or higher than the high point of the second tank!
Be sure to account for how level your floor is, and any warping in your material.
Links:
Power Strip: amzn.to/3RrJebQ
Hook Up Wire: amzn.to/3nYIr4E
Pond Filter: amzn.to/3ysVb8N
12vDC Pump amzn.to/3uGag5P
Project Box, 7.8x4.7x4.4 amzn.to/3NWBETY
Speed Controller: amzn.to/3Pg7mfQ
12vDC 10A Power Adapter: amzn.to/3OZ8chk
Barrel Plug to Terminal pairs: amzn.to/3AGZwYL
Barrel Plug Pigtails" amzn.to/3bSQ4a7
Thru Wall Barrel Plug Pigtails: amzn.to/3AGcFkv
Feel free to find alternates, specifically the pump! As long as you size the power adapter and speed controller appropriately, using a higher flow pump could be a good thing.
Let me know what you think, and please share any improvements you make to this idea!
Inspired by the 'XR Filtration' video by Schwoeppes Shop, check it out for another reference
• Crossfire XR plasma ta...
Hashtag Goals. Love it, brother!
That’s a seriously badass set up! Super impressed with all of it.
Air bladder is the way to go imo. But that some serious work well done
Nice work. My favorite line is caulk the hell out of it!
Nice man! 👌👊
Looks familiar. Good job. I shortened my slats so the pex can go below the table rail level so I can slide material on and off table. also installing a T fitting inside the water table side allows for more adjustment allowing water in 2 ways and you can turn, spin the T to speed up or slow down flow.
worker dream .👍👍
Very nice! Looking at the Langmuir XR now - How did the setup of the Everlast Plasma go with the XR? Looking at the 82i - Thanks!
how do u keep it from splashing n the sides, i think my psi is around 65, ive even lowered the water to try and help. have u made anything for squaring sheets on the table
So what happened to part 2 of the video?
How does this filter all the crap floating on top after cutting? I'm not sure why you are recirculating fluid because that little surface drain isn't going to allow all the floating stuff down it.