You got bad luck like me😅. I have 4.4 HRS and 18 miles on my XMR. I swamped it on the 3 day, the whole roof was under water. You were in the top 5 reasons I bought the same buggy. Great videos love them.
I don't even have one of these Can Ams but I watch just to hang out with you for a few minutes 😅 So is the only reason for not pulling in reverse because of the week driveshaft? If so, maybe you can now that you have a stronger one?
Yeah, the motor is in the back and the drive shaft for the front end is long. So when you load up the front end and pull it dosent end well. Now I have a new weak link to find with the strong drive shaft lol
You got bad luck like me😅. I have 4.4 HRS and 18 miles on my XMR. I swamped it on the 3 day, the whole roof was under water. You were in the top 5 reasons I bought the same buggy. Great videos love them.
Man that sucks!! I love the bike no doubt!!
Heck of job. Nice work! Hate crawling under my Defender...lol. Hopefully it’s just for fluid changes and not for what you just did. 😎
Thanks!
Look forward to your vids !/. Super informative
Thanks so much!
I'm glad you got it fixed!
Me too!!
@@EverydayMan how can I contact you about the generator set up video. I have the same generator and have a question. Please I need your help.
@@txguy1768 message Everyday Man on Facebook
@@EverydayMan is it a group or personal
@@txguy1768 personal
Sandcraft sells an extension tube grease whip for theirs so you can add grease point on the floor. Maybe you can do something like that
I don't even have one of these Can Ams but I watch just to hang out with you for a few minutes 😅
So is the only reason for not pulling in reverse because of the week driveshaft? If so, maybe you can now that you have a stronger one?
Yeah, the motor is in the back and the drive shaft for the front end is long. So when you load up the front end and pull it dosent end well. Now I have a new weak link to find with the strong drive shaft lol
If you don’t mind me asking, what exactly were you pulling on when this happened?
My son was trying to pull a post out of old blacktop.
How did u get the plastic channel off, did i just drill out the rivets and how did u replace it
I drilled out the rivets and replaced them with screws.
Do you have any noises/honing with that driveshaft?
A little vibration, no noise.
I have the same driveshaft. And when I put it in 4x4 and start moving. I get a decent amount of vibration from it. Have you had this problem?
Does your machine creek when you ride around?
Yup, they all do.
Mine was making a lot of creaking I tightened all the roof bolts they were so lose over time and also grease the A arm zerk fittings helped a lot
Go get them, Hillbilly
Glad you got it fixed!
Me too!