always put truck near and angle it so you do not turn loader...save alot of $$$ on rollers pins and tracks etc.
Dobré video, to se to těží stavební jáma s takovou mechanizací.
tip, when your going into the pile raise the arms a hint to put down pressure on tracks and get a more full bucket.. i know bc iv been doing it for over 38 years
I was Told , if you Lift the Arms ! Then your Damaging you lift Hydraulics !! Just Roll the Bucket back ! And Creep it Forward ! Then back out !
Recall a 963 being dropped into the bottom of a coal ship at Liverpool docks from crane many years ago, track balance bar and loading frame were bent, but repaired and went back into service, tough machines.
very good operator.
Pásový caterpillar je moc pekný stroj
Good video - that driver knows his job!
Je to točené u Bohunické nemocnice v Brně ;) Pecco jo to maš pravdu šlo to jak po másle
977L is just as fast !! 973 might gain a bit due to counter rotation
Luxus! A kde jsi to točil, není-li to tajné? :-D
To get a ripper and the third valve on my machine would cost me $20,000 i dont have haha
Next Time ! Get an Excavator !! And at least a minimum Three Trucks !
why so far?? your should be able to load right after you take a scoop.. if anything he is way to far away!!
pekny caterpillar aj video len nech sluzi ten stroj videt ze strojnik znim naraba ako sa slusi a patri a ne ako poniektori co videl nestaraju oto o taky stroj sa treba starat
only 2 scoops? those trucks can hold more then that, load em up
+Skankpronger If they are hauling offsite they are probably worried about weight restrictions.
And bring the truck closer too save fuel
Les falta un votaso son3 y debes aser mas boteo para que no patines mucho las cadenas te lo dise un sobrestante
I really dislike this style track loader...I like the old design. The cat 983
He can fill a bucket, I'll give him that, but park the truck closer.
I LIKE TRACK WEAR ! i LIKE TRACK WEAR I LIKE TRACK COZ I AINT PAYING FOR EM !!!!!!!
Bad ! Enough ! With Rubber ! TYRE !! WEAR ! On Wheel Loader / BOBCAT !
is this loader operator getting paid by the mile ??
977 strong but slow
So inefficient!!!!! These guys wouldn't work for me. That's for sure, unless they were paying for their own undercarriage!!! So darn wasteful!!!!
How NOT to operate a drott.
fucking waste of a 973.
下手くそ なぜダンプの方を前後させない?? 効率悪すぎだろただでさえ遅いのに
Sehr schönes Video, sehr schöner Maschinensound, danke!