With regards and respect to your service In ABB inverter model ACS580 we have error 6581 During continuous operation, it gives this error every three hours, and in case of fault, the inverter is turned off. please guide me Of course, it goes without saying that we have also done a factory reset Thank you
i have inverter ach580 am working today my vfd fault is AFF6the fault is id run fault when the drive is run command the vfd triped and ahow fault of display is id run plz help me thankyou and gaid me
Have u connected the motor sensor to the vfd? If yes the motor temperature rises. Check motor temperature if ok then sensor of ur motor is faulty disconnect that or replace
Amazing
With regards and respect to your service
In ABB inverter model ACS580 we have error 6581
During continuous operation, it gives this error every three hours, and in case of fault, the inverter is turned off.
please guide me
Of course, it goes without saying that we have also done a factory reset
Thank you
How to change its out put frequency??
ie How to change the speed (purpose of this drive is this so pls explain about it)
czcams.com/video/h24LyaPekh4/video.html plz watch this video
i have inverter ach580 am working today my vfd fault is AFF6the fault is id run fault when the drive is run command the vfd triped and ahow fault of display is id run plz help me thankyou and gaid me
I'd run fault is not causing vfd to trip just check the parameters in group 99 feed the motor nominal values correctly
How can I clear a fault of 4981 on the ABB VFD Model ACH580.
Have u connected the motor sensor to the vfd? If yes the motor temperature rises. Check motor temperature if ok then sensor of ur motor is faulty disconnect that or replace
@@rafiautomation Thanks for the quick response.No I have not connected the motor sensor to the VFD.
Its AHUnit that we want to commission and the motor is not even hot.
Check parameter 35.11 if any source is selected by mistake
Or check the paremeter 35.12 and 35.13 may be temperature limit I too low need to increase it
The fault is External temperature to high
czcams.com/video/wafPmHXlMQ4/video.html