RC Car Stutter Fixed

Here is how I fixed my RC car Cogging problem. Turned out to be an issue with the power connector to the motor.
How to Replace the Center Driveline Bearing video link
• Traxxas 4x4, How to Re...
Intro music: Jim Yosef - Eclipse [NCS Release]
Outro music: Tobu - Hope [NCS Release]

[@modex20]

God bless you and this video. I never would have thought to check those bullet connectors. One of mine was all corroded.

[@TeeTimeTales8]

Bro thanks so much for this vid I have been struggling for hours trying to figure out what my problem was thanks man ❤

[@erhartsmith4706]

Awesome video, thanks very much for showing what the issue was. Much appreciated!

[@MaximoDeep]

Thank you for the video, had the same problem and could not figure it out. Running again!

[@warrenkennedy8280]

Just cut the wires and solder them together, sheez

[@tootlepuff]

Same thing happened to mine I Just buy new bullet connectors pop the cage off the new one and put it on the old.

[@dejgas3691]

Hello so my rc car have quite the same problem so i checked all the connectors as you showed but they are good.
If i put throttle when all four wheels of the rc car are in the air it spins normally but it doesnt seem like full power and if i put rc car to the ground and press throttle it doesnt move it sound like it is lagging but if i push the rc car and press throttle then it moves and drives but it goes very slow (before that problem it was going around 40km/h)
I hope you understand the problem and i am very sorry for my bad english because i have a bad knowledge in this language.
Let me know if the problem is salvable, thanks.

[@RandomDIY09]

It could be your drive shaft, most likely though it is a worn out spur gear. I had an almost bald one. Would be a cheap fix, only you need to disassemble the motor housing.

[@dejgas3691]

@@RandomDIY09 i checked all the drivetrain and it looks fine it spins good so i am worried is something on the electricity
also the air fan was changed with bigger one and it is possible that the fan takes too much power and there is not enough power for motor? i am not very good in electric so i am just guessing

[@okeselmen1179]

​@@dejgas3691i have the same problrm