- 10
- 7 510
Irby Jones
Registrace 1. 10. 2011
4th axis trial run
4th axis trial run on bench using LinuxCNC to control two AC servo motors. One drives a translation stage moved by a zero-backlash ballscrew, the other a 5C spin index with a 4:1 cog belt reduction.
zhlédnutí: 29
Video
Shearing tool use on a metal planer
zhlédnutí 366Před dnem
Shearing tool in use on an old planer cutting an aluminum top plate parallel to the base of a translation stage. I wanted to show how the chip spiraled off the tool.
Closeup of roughing tool in use on 1910 Schneider & Goosmann metal planer
zhlédnutí 226Před 6 lety
Closeup of roughing tool in use on 1910 Schneider & Goosmann metal planer
Planing a lathe saddle on a 1910 Schneider & Goosmann metal planer
zhlédnutí 4,8KPřed 6 lety
An old Apex Tool & Cutter Co. roughing tool in use on a 1910 36" Schneider & Goosmann metal planer. Planer run by a 1HP Lima motor/4-speed gearbox, with a VFD driving the 3 phase motor. The underside of the saddle for a 1920's Hardinge Cataract Quick Swing lathe is being relieved so the saddle bears only on the front V-way. Wear on the saddle was allowing contact on the flat areas on either sid...
Shearing tool on a 1910 metal planer
zhlédnutí 783Před 6 lety
Old Apex Tool & Cutter Co. shearing tool in action on a 1910 Schneider & Goosmann metal planer. Relieving the underside of a 1920's Hardinge Cataract toolroom lathe saddle.
1910 Metal Planer
zhlédnutí 564Před 7 lety
Originally run from an overhead lineshaft. Now is powered by a Lima 3 phase motor/4 speed gearbox and VFD with Fwd/Rev. Table is moving at about 18 fpm.
You are a wealthy man sir. Even if I could afford a planer I couldn't afford to give up the space it needs.
Looks good Irby. I still have my Cataract QCS. --Doozer
Hey Irby. I also have a 1920a Cataract QC swing lathe, Also have a Rockford 36" hydraulic planer. Nice work.
Old & new for sure. We just got our Walter Bros. planer under power, or should I say OVER power, line shafts, Check out ours @ NORTHERN MINNESOTA METALSMITHS FLAT BELT MACHINE SHOP
Interesting tool Irby... any details on it? Commercial or machinist made?
It's made by Apex Tool & Cutter Co. Inc. I think the one I have is old, but the company is still in existence (www.apextoolandcutter.com) and the cutter bits are listed there. I have a couple tool holders and lots of pre-ground cutters. Here's the holder and the shearing bit shown in another video. Too bad I can't put photos in the comments. I'll show some photos of the holder and cutter bits over on the Yahoo groups.