Video

Best instructions I have seen. Seems to be the same for a 2012

How long it lasts?

Super helpful video and you swayed my decision thanks man!

Nice Jeep! What brand of fenders are on the front?

Good morning. what is the engine oil temperature for fast highway use 82mph and normal road 56mph? at what temperature does the thermostat open? THANKS

Well, it was a really good discount, so yeah, I'd do the same

Man! How has this cover been holding up after a year of trying to work it down that windshield with the light bar mount on? Just curious cause you looked like you were struggling with it to bring it down. Would like an update on it. Looking to get one for my son's Jeep.

What did you do to get the black plastic piece off of the Big battery terminal? It's a pain in the ass.

Just a quick question thermostat issue is when the vehicle its running in the freeway and the (transmission overheat light) came on??

Those are Metalcloak Overline fenders in the front.

Are you still liking it. Wondering if it will work with the OEM door surrounds.

Do you replace the transmission fluid?

Well done video. Thanks for showing the issues with the lower bolt access.

Do you replace the fuel filter ever oil change and roughly how much do you pay per oil change. Thanks

Thanks so much for the video. The Dealer here in South FL wanted $730 dollars to replace it. My engine warning light came on and gave the error. So did the code disappear? Also did you use mopart parts or third party?

Should have heard the dura shit yesterday morning sounded like a idi truck lol

how do you like them as compared to 4.5 backspace

Nice !! Whats the offset on the wheels ?

Hey Grant .. I've got the same Gladiator as you ... same color too :) ... I've also installed the same Rock Slide Engineering steps on mine. I do have some issues too. Driver side seems to rattle ... I'm assuming I'll need to take apart to see what's loose. Also, sometimes the step seems wobbly ... on my passenger side, it will sometimes not deploy when door is opened. Shutting the door and reopening seems to fix that. I've had for about the same amount of time ... I think mine are Gen 3 too Joe

I have a 3.5" lift no cable issues but I do need to know what springs you used.

I tapped into my high beam wire to power the relay for my lightbar so it just comes on with my highs.

just an O ring, no old school gasket or sealant?

Should we completely drain the fuel tank to do this? How often do we do this?

Evidence that you need to see a Urologist! Minute - 14.5 🤣

Unless you're using repeters the range is essentially the same as using a CB.

any error code? look super clean great video btw

Hi. Is it only filtered water with bit of fuel coming out through the yellow screw hole, or all what was left in the fuel tank? I'm asking to ensure if I could replace these filters without draining the tank. Thanks for the video.

How you like them?

Wish you showed more of what you were doing was not very helpful but thank you for trying to make one

Thanks. Time to do mine. I’ve been reading about the high pressure Bosch fuel pump failures (CP4) which sounds like a total nightmare. The takeaway is that very thorough priming after a filter change is essential, as air in the fuel damages the pump. Also, NEVER EVER run out of fuel.

Have the covers faded at all, thinking of buying for my gladdy

This is a million trillion times more helpful than quadratec’s video and instructions. Thank you

Any idea what size threading the yellow screw is? Mine is stripped out and trying to find a replacement without having to replace the whole housing.

Did you ever fabricate anything for the RSE steps so when you ope the tube doors the steps come down? The door delete kit from RSE just seems hoky to push a button Everytime you get in and out

I’m sold, I found a seller that owns a jt and letting these bad boys for 650 so I’m about to check it out. Thanks for this video your jt looks good tho I’m getting these doors for my 21 jl Willys

Sorry. Can’t find the part numbers that you mentioned. Thanks.

Thanks for the tutorial. Are you still happy with it. I was looking at this one for my gladiator but just ordered one from Venture. Just wish I had that diesel. Haha

12:32 sounds like it backfired

Thanks Grant for taking the time and putting this together for the WK2 community! I had the P0128 code show up also and will be following your video to replace the thermostat. I too have had great luck with the diesel! Again thanks for taking the time to put a video together and sharing!

gran video, me das el numero de la llave?.. saludos dsd Perú

rough country mlc-6 is a must have.

Fun fact! That lower battery box is an excellent place to smuggle drugs.....allegedly.

Yep that sounds like a jeep problem 😂

21 Mojave front shocks being replaced under warranty, terrible creaking noise. Very disappointed

Thanks,I'm about to do this.

Must be a Very long bolt?

My 22 willys ecodiesel came stock with rubicon shocks.

Looking good like a man! Great project!😊

I love my ecoDiesel.