Video

❤❤❤

Did you Lift the engine up?

Va

How do you know when they need to be replaced?

Clark Brian Jackson Mary Garcia Donna

Thanks for a simple video...❤❤❤

Why did you change the shafts? you could have changed the motors without lowering the differential

Might as well change out the starter lol

Where can I get the headlight diagram

Thanks a great video helped me a lot 👍🏽👍🏽

Youll never figure that back out.

Good

Terrible video

Where is the place for the vaporizer please?

With the 79 series? Do you have to remove engine to changeout turbo?

Excellent video. I was about to give up on installing a clutch fan on a 2018 Nissan Titan. You nailed it. Didn't understand your language, but followed you step by step. 😅

L4

I was wondering why my ac wasn’t working. I was under the impression that it was one belt for everything. My vehicle doesn’t have the ac belt on💀😂

good video but it's missing how you actually fit the new seal into the engine, or any tools needed, i have heard that if not fitted correctly it just leaks again, and sometimes worse.

Got this code today..looks pretty simple..thanks a great deal

Did that clear the code..was kind of hard to see on the scanner

Very nice

A small air blower would be great to blow out the excess dust before removing parts.

Thanks from Australia. You helped me out with this video.

Good

Pretendo de uma placa.

😂 Checking oil level in R Are you working on an 89 corolla???

What year???

Brother hope someone replies to this. My car leaking fuel from tank. Only when full tank. After 5 mins leak stops. And car runs perfect. Can it be the fuel filter ?

I just pulled my water pump from a Ford Explorer, why does the pump have gasket sealant applied over the rubber gasket? Mind you this was bought new not used and first time changed at 166,769 miles.

No no por abajo es super más fácil

Thanks for the video, is there a quick method for bleeding the fuel off the high pressure line?

Thank you for the video. Replaced mine on a 2023 Armada that was making the loud semi noise. Takeaways from video- fan clutch drops out the bottom, remove rock shield from underneath, fan shroud bottom half removable out the bottom, remove oil filter, use auto pick to release red clip on electrical connection, need small hands to get nuts on studs for fan clutch(otherwise took me 90 minutes). If you can change your oil, you can do this.

Hey good job man. Nice work holding the camera with one hand and working with the other. I have the same car and did all this work also except I reused the old control arms and fit superpro poly bushes. I replaced the diff pinion bushes as well. Much better. But have not done the rear diff bushes. Would have been good if you showed how you fit the new ones in. Great work though 👍 That car is as dusty as a camels sandshoe 😂 145000km car.

Bro. U ok?

Boa noite pessoa o meu carro não tem corrente nos injector...

you are great!!!

Good work boss

Is the fuel tank pressure sensor on top of the tank?

What did you use to hold the gasket in place? I heard some people say use silicone and other people say never use silicone.

Cuales son las marca de los piñones

Where is your garage location!?

علط انهوه يصب الما۽

Were you buy the part how much was

Hi CAN YOU PLEASE LIST THE COMPONENTS THAT COME WITH THE NEW ENGING OF 1VDFTV FOR V8 LAND CRUISER

good

Thanks for the video. Is it so necessary to remove the engine to change the belt or is it possible without removing it?

What tools are needed to replace a cylinder head for tiida

Oil gaskets at 09:05

Thanks a million for doing this .