Video

LOOPER. No.

How to set needle down

I have learned a lot from your videos, can you please show how to adjust the tail trim length so the thread does not come out of the needle? Thanks!!! Best ever tutorials for Juki LU1510.

Or silai krte samay agar machine rokte han to rukne ke bad machine 1 tak back kyo hoti han yhe video shear kre please

Tension tepar spring ko kaise replace krte han video

Content number send me

buenas una pregunta yo tengo una juki recta pero trabaja las 27/7 pero me esta fallando mucho que me revienta hilo y me hace chinito el hilo le hago su ajuste pero me sigue reventando hilo como puedo solucionar ese problema

Hello I have got E221 but couldn't access to P118 do you have a solution for this? thanks

❤

Wonderful video! Can you tell me how similar the procedures on a JUKI LU -1508 would be? Can I achieve results by following ❤ with some minor differences in mind? thank you for everything!

Thank you sir

Very important video. Thanks

What problem to cut cotton

Price

Over lock ka bade lupar ka dhaga baar baar Tod Rahi hai kya kare bhaiya ji plz help me

Dürkopp Adler sewing machine. The key code and the E5 code are given on the screen. How does it work? Thank you very much.

Super

Thanks for sharing this video

Please I need guid for my two needle machine to have good sewing

❤

Super bro

God bless you for this tutorial.

Thank you...saved my week, changed the take up spring all on my owe, whoop whoop😊

Hello dear, how do I fix what I have 07?

What is the actual measurement of timing .we need how we set machine for thin n thick febric.

How do I adjust the tension of the bobbin

sir needle hitting the shutter how can I slove the problem

Gracias mano

Very good

Wonderful!!! I have a JukiTL98q. Not sure if this will work identically but I am now wiser because of this video. Well done! Thank you.

My 1510N-7 of 15 yrs will have to be re timed just like this. It will work fine for a while then it stop's trimming. If I reset it just like this video it works again. It repeats this again. I can't figure out what is doing this. Very intermittent so it's hard for me to figure. Thanks for this video cause it helped me get my machine going again even thou it will repeat. Any tips?

I can't believe it's so old and rusty looking. Mine is 17 yrs old and thou used it still is in great shape.

Is there a video of the problem ?erer

So good

Sar bolkar sikhaiye hindime taakin samajhme aye

How do you take out the whole housing from a juki 8300 please

What is the bias/webbing underneath for? Im curious.

Thanks a lot

Nice bhai.. Love.. You

Esdi ly needle konsa use krte ho

This video would me so much better with a little context. It needs someone to explain some of the basic things that are happening: assume that the needle bar height is correct, then time the lower looper to the needle, then time the upper looper to the lower looper, etc.

This video is helpful. Thank you very much!!!!!

Computerized jo hoti h

Bro double niddle k cutter ki setting btado

Nice video, just what I wanted to know. Keep sharing!

How to remove e221?

Thank u so much u solved my problem with help of ALLAH

Hi

Thank you so much for this video! You saved me a lot of time and grief! I have a Wimsew machine (cheap but terrible quality) and the video was perfect to show me how to replace the spring.

I didn't understand the part about the marking No. 2