Video

It is price gouging for sure but unfortunately for most HVAC companies it's standard practice. They are thieves. They carry 5 gallon buckets of Vaseline in their van they fuck so many people.

Nah the most important part was patching the hole. Why did he just cut the video. Lazy

For sure that capacitor he took out looks brand new

I did have that issue at my last house, but the ceiling structure was different. With this method, I haven't had that issue.

Depends on the unit specs. But to remind an evaporator is A lot more work than people think, you have to recover the refrigerant and then you can cut and replace the evaporator or unburze and braise the new one in, then you have to do a leak check then you have to pull a deep vacuum get rid of moisture and then you can put the new refrigerant back in and charge up if needed. Call around to some other companies and get some quotes, quotes should be free so it's always nice to compare. But always go with the company that is more trustworthy rather than the price that looks the best

Pretty average price for most companies. 4-6 hours of work, Evaporator price + $400-$500 dollars per hour of labor is standard for a reputable company.

Had mine replaced in 2017 it was $1500 but the guy was an independent and this was 7 years ago. Plus the evap was pretty easy to get to.

Get a quote from an independent hvac guy. You can almost buy a complete split unit for that, not including installation.

@@markkotyakov2978you don’t always have to full recover refrigerant. You can do a pump down and store the refrigerant in the compressor and then sweat the lines at the evaporator and remove then install new one do nitrogen leak test then if no leaks pull your vacuum and if it gets to 250 microns then let sit for 15 minutes then let refrigerant back out of compressor check pressures then see if you need to add a little extra from a little loss and bam. Your done. Oh don’t forget to replace the filter dryer in the process.

💀💀

If you ohm out a capacitor and there’s no continuity the it should be replaced. Make sure to discharge the capacitor before replacing.

I bought and replaced the exact same capacitor 55+5.

Survival of the fittest only the strongest of the compressors shall survive 😆

Does it cause any harm to install a higher microfarad capacitor?

@@TheRegularNetwork yes and that was the wrong size cap originally. it's going to tear that compressor start winding up with time. If you want to confirm it just look at the compressor model number and it says cap size right on it

@@robertbell525 yes it degrades the start winding of a compressor which shortens the life of it.

Thanks for watching

Thanks for watching

Thanks for watching. Mine does not swing excessively. I think the swaying has more to do with the size/weight of heavy bag you purchase.

@@TheRegularNetwork Thanks!

It took about an hour and a half the first time because I had never done this before. But when I went back down to do it again, it took about 20minutes. It's a quick replacement if you know what you're looking for.

Thanks for watching. It doesn't vibrate through the house. It vibrated bad at my last house, which was older construction without trusses

Thanks for watching.

Thanks for watching. Here is a link to the exact items I ordered from Amazon, but it looks like it's no longer available. I'm sure there are newer alternatives. Link www.amazon.com/gp/product/B07CVD6T75/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

I used a 2x4 and (4) 3" deck screws

Thanks for watching. The chain is more than sufficient for this type of load. It's holding up nicely.

Thanks for watching. The acid would be applied before the sealant. This is done while you're still in the clean-up stage of the installation.

I don't have any tips for a permanent mount in an apt. The best bet is to get one of those heavy bag stands to mount it on.

Thanks for watching. I didn't drill directly into the truss just for my own preference. Many people do it. I just wasn't comfortable drilling a half inch hole in a truss for a heavy bag with this much weight and movement.

Wow Thank you and Thanks for watching.

I believe you can still use the DVR unit via wifi. You will need a monitor to do the initial setup, regardless of the type of internet connection you have. Once you set you system up, you can disconnect the monitor and just look at your camera feeds in the mobile app.

Sounds good man, thank you!

Thanks for watching. Glad you found a solution

Thank you

Thanks for watching. I'm glad I could help you and your husband with this one.

Thank you very much!

It came pre-filled from the store.

🏏

The original capacitor was pretty old so I didn't see the brand.

I disliked the fact that you didn’t discuss any of the safety issues one needs to be concerned about when changing an apparatus that holds an electrical charge. First rule in the book safety first..

Once I made contact with the supplier, I received the replacement within a week.