Video

this is what my mariner is experiencing. I wish I could just disable it without taking the car apart.

I have been having this video saved so TODAY(07-28-2024) i tryed this solution, will definitely update until the next time it goes off❤

Hello’ I’m dead with this issue. My neighbours keep complaining and I’ve seen 5 mechanics and no one is able to help :(

Merci

What a shity design.

Miracle juice

If i leave the doors unlocked will that stop the panic alarm from going off?

2015 Buick Enclave too thanks

WD40 works as well

1 year since this treatment. The chain noise is gone. Fuel economy is up 13%. The cold start rattle is still there. The engine is running very smooth. I am very satisfied with this treatment.

It is still leaking a bit. Next is to remove the whole headliner and detect the source. I think there is another leak at the back sky roof area.

I had this problem with a Mazda 3. Disconnecting the hood switch stopped the alarm from randomly going off, but created another problem. A few weeks later I noticed my battery was being drained. I checked the circuit for the door monitoring system and noticed there was a high draw. I fixed the issue by soldering the wires of the hood switch together to complete the circuit.

Hi, Also interested to know if you were able to fix this issue?

Thank you , was getting bubbles out of the gets and flow kept going down until the pump auto off. Though I clean the baskets, replace the skimmer sock every week, clean the filter cartridge every month and it's just 3 years old. Happy this is resolved. Thnx

I did everything from disconnected horns and took out fuses. The problem went away for a while and during that time I was driving without horns. Now for some reason, it started to fuk with me again. So this time, I manually lock the doors and it still goes off by flashing lights buy eventually it stopped. After searching further, I make sure I take out all horn fuses that marked S which mean security alarm. I also did what this guy did with the hood hatch wire but I didn't splice them with green and yellow. I guess if the fuking thing started flashing my lights again then I will spice the wires.

I have no sunroof, just roof rails! andthe seat belt is stinky! got to see if its covered under insurance.

We have the same issue in our 2013 Sienna. May I ask which city you're in ? Would you try to fix this for us :)

There is a video on CZcams showing how to replace this bearing without replacing coupler. Buy the bearing and upgraded dust seal and replace yourself.

Worthless

Woulda been a nice shot, but no vent on my model. Thanks anyway!

Same problem i have with a Renault laguna coupe.. The bonnet sensor

Hi, where's the link to fix it for good? I have a 2011 Camry. Thank you.

I know this vid was posted year ago. Did alarm ever go again since then?

My sienna is leaking at the exact same place. Thanks so much. I spent over 5K last year replacing the outer seal of sunroof and replaced ceiling of my van by Toyota. This year it leaked again so I’m hoping with your video I can get it fixed for good

Thanks

I hope it works on my 2014 Cadillac im going crazy the alarm goes off at 1am any time

❤

I have broken the monitor

Hi--I also have a 2011 Toyota Sienna Limited AWD with the "SAME" roof leak. Interestingly, it seems like my roof leak is "also" coming from the passenger side. I've followed your videos and I know you've done a particularly deep dive into diagnosing the root of this problem. I'm curious if you've had any luck in the past year since your last post.

how did things go with the Kube?

Can you use WD-40?

You are awesome man

Thanks 👍👍

Where would this be on a 06 mustang ?

Any updates? Did your timing chain rattle go away?

Nice job! It does suck to have the incorrect replacement part, been there, done that same thing with my Moen shower cartridge. The rubber components in that cartridge assembly get hard as a rock or the rubber seal rolls over on itself while you are trying to remove the cartridge and jams it up. You did not mention if you were using the cartridge puller tool or if you were just pulling on the stem freehand. The cartridge puller makes sure you apply a square even pressure while pulling on it, but there is still no guarantee that it will come out with a cartridge puller either. You saved yourself a bundle by not having to replace the wall guts.👍

I have a shower with the 1225 cartridge which hasn't been changed for about 20 yrs. I'm expecting I may have a similar experience, so I appreciate the tip about threading a screw into the cartridge. 👍

My Kohler diverter is a plunger type in water mixing assembly and it's stuck in for shower. I have to pull it out to use the tub but it always binds up. I wonder if it's similar? I bet it may be.

I’m gonna try this, I got the same car alarm going off randomly

I have this same issue but the sun roof drains were clogged. I stuck a long stiff wire down the small drain tubes and the leak stopped

Such an idiotic design

How did you isolate it to the hood sensor?

Thanks for the educational video this happened to me it was a little aggravating to do , but saved me an absolute boatload of money thank you 😊

Thank you 😊

You try this

It worked....thank you very much for sharing this video. I stayed up last night until 4AM to turn off my car alarm at random pace. Then I got fed up went online and found this video. It worked like magic!

Thanks. It will break the bank 😂. Mine needs 4 cartridges and they are 100.00 dollars each . But like you I spent hours trying to figure out why low pressure. You confirmed my suspicions.

May I ask why not just use WD-40?

I gotta 2013 venza started randomly alarming today

My gosh, thanks A LOT. I was checking with other models where that plastic section should be easy to take off with a knife or something. Then I found your video and discovered it had screws.