Video

what are the symptoms beside just getting it from a scan code? I got a code and my 08 is running rough. also a p1404 p0306 po300 and po0303

Where are licated mann thgs what i need for my ca?

Buen trabajo buen video

Did the car start after new pump?

Did you learn how to program that key?

My light is still on .

Todos los tornillos de la tapa se tienen q quitar para q salga sin tener que guitar el booster

Which engine is it

Enbudo conque

I just spent about 3 hours trying to get mine off. I got every bolt except the small 12 mm on the bottom left near the alternator. I couldn't get a wrench to fit in that space. Had to order a flex ratchet from Amazon, hopefully it works.

You saved my road test, 🤣

😮no no no si pa sacar la tapa esta cabrito

I did mines without removing those parts, but I guess everyone have different way of doing it lol.

Thanks for this! Worked like a charm for my 08 civic!

alot of dirt went in the intake

So is your fan bad or what because if the fan is bad it's going to keep overheating I know are got to be released are has to be released

Did you drain the oil or is that how much spilled out with oil still in it?

Esta valvula puede ocasionar que se apague el motor o que no encienda? Tengo una Silverado y no queria encender desconecte esta válvula y encendio a la primera.

El mío no prenden las luces de la placa, ni la cajuela abre con la llave inteligente, que puede ser?

I removed the belt from the top it was easy

So my girls car seems to struggel after 2nd gear, then jerks while acceleration after that. Code comes up as the sensor but thats been replaced, goes up to 3-4 thousand rpms but barely goes anywhere. Could this be the cat? Seems like the only thing left to do. Any help with this would be appreciated before I replace it, been to a mechanic and dealership and they couldn't pin point it just got the same code i did bank 1 sensor 1 low

Thank you so much!!! And you did a wonderful job editing the video. Short and to the point~nyan🤓🦁🦁

Thank you, even though I can't understand a word you're saying. You have pointed it out for me, where other videos only referenced the V8 models. Now I can replace it, because I have the code popping up.

Saludos tengo un problema parecido en un nissan juke solo que aparte de las luces de la matricula no enciende la luz de posicion trasera del lado derceho. 😢

Here is how to remove the panels, wish this guy had shown how to do this: Search CZcams for "Honda Civic HVAC bulb replace 2009"

Whoa!!! Watching this is giving me VERTIGO like a MF....need Dramamine and an Ativan to watch it all.

Thank you so much for this video…👍👍👍👍

So you didn`t even took it out steering link end and lower ball joint? How the hell you can turn so much spindle to take outter axle out? :?

My controls aren’t working on my 13 Elantra

where did you get that gaz tank??? is there any other tank we can trow under there?? universal one maybe do you know ??

"I hate that part" lol we have all been there brother

Thanks very informative.

Mumbler

Está bien el video, lo malo el ruido que le puso, no deja oír lo que dice y además es muy molesto.

Painful to watch. Took him five minutes just to remove B terminal cap . Sheesh!

Thank you for the video brother! Can someone tell me if there is a video for 2010 Mercury Milan 3.0 transmission filter replacement, ive looked and no luck finding one😅

Just pull are you weak

Thanks for the video... just purchased a 2013 Chevrolet Sonic LT Hatchback and horn was not working. It was going to cost like $350 after they diagnosed it, I said no thanks and went to youtube! This video turned my $350 mechanic bill to a $20 part from ebay. Thanks again!!

I'm having trouble getting a breaker bar with socket into the narrow area to relieve tension on the belt. Where did you get that breaker bar? It seems very useful and thinner than mine so better in tight spaces. I've searched online and was unable to find something similar!

Did you buy the part from dealer ? Did it come with new set of keys ?

I have problem no power on it some time it work and some time no power i checked all fusses all working i gound the wire compressor work so it means i must change it ?

Thank you for the video. Question - after you have replaced only the gaskets, do you need to adjust the valves?

Nice to know. Thanks bud

So thankful for this video. My horn works perfectly. It’s easy to do. Follow the instructions and you’ll be just fine!

Thanks bro

always gotta discdonect the battery right?

How many hours should this take? Ours is a 2017 - a auto repair place near us is charging about $1250 , Cadillac wants $1600 ….

Did u have to do a relearn after replacing it ? Bc after I replaced mine , my check engine light started flashing & car running bad

is there a torque spec on the two bolts that hold down the thermostat housing?

Did you have to drain the transmission before doing this?