Video

thanks, this worked for me.

From my experience cheap rubber vacuum cap never last (a full year IF YOU ARE LUCKY), man it up and do it once, get short silicone hose and cut nail/metal rod and plug into end, other end go to intake pipe/nipple. Very good video, and nicely explained. Thank you 17:27

I had a L15 engine and tranny swapped into my 2001 Insight. Drove it 30k miles with many autocross and track days. The L15 setup was ideal for performance as it didn't put too much weight on the nose and was bullet proof. Just recently upgraded to a 2024 Civic Type R and have fond memories of the L-sight (czcams.com/video/KUPdOTWMl9U/video.html).

What exhaust is that, i need it for mine haha

Nice🤘🏿

so this same set up should work with 3uz also right?

is it still around?

Where did you get the transmission oil coolers?

Wow

Thank you so much! I'm going to give this a try.

Trying so hard not to fall down the same hole with my Aristo 😅 but I really want to clean up the engine bay and single it!

mr2 looks great in grey

Well done.

Part 1 said its a Nissan ka24 5 speed transmission

where are the vids just picked up a 147 would love to see and update on what's been done with yours

What ecu are you running? I have a 1990 MR2 with a blown Gen 2 engine and looking at picking up a Gen 4 3SGTE from a ST215 Caldina. Unsure what to do ecu wise…looks and sounds awesome man! 🤘🏼

I need this car

Hi I have a similar issue. Just like yours I’ve installed a stereo. And the top display works. But I don’t receive any signals from the AC. Basically no AC control modes or anything like the display on your video. But I can change the AC control from the temperature . Ex- if I press temperature down all the way it would set to minus and very cold air, and if I set it all the way up it’s hot and activates the feet blower. I’ve checked all the wirings and tried your method but no luck. Would really appreciate some help. It’s a jzx110 conversion.

Looks like the tensioner can be replaced without removing the chain cover.

Piece of shit cars when it comes to windows

Hello, how did it hold up over the years ?

I did this exactly and when I started my Honda when I let go of the clutch I hear metal clanking I don’t know what I did wrong

how did you get the top part of the back seats removed ? im having trouble doing it and im not the best at working with cars.

Ko-kee. Not coo-kee.

installed two now, issue still persists? (knockoff amazon ones)

can a sequential transmission fit in the Ls400

driving without a tune is crazy

awesome

Do you have a link for the same paint ?

I got a 93 T-top, which leaks. This window adjustment is what I was exactly looking for. My drivers side window won't close all the way (dig into the seal) like on the passenger side. I will try this tomorrow to see if it works :)

Can you add the extra of the pionner parking sensors to that model of media console

how much was it in total?

you might be able to get the gauges in the dash to work , they change the speedsettings all the time like when they intall bigger diameter tires on pickuptrucks so it should be possible altered electronicly on the ecu with a laptop , might otherwize be able to change the pulses by running it through an arduino perhabs converting it to the amount of pulses needed to run treu im a little supprized no one has done this conversion to go dragracing in the fwd class as these cars are pretty light and aerodynamic compared to the average crx or civics they use , dont even need carbon fiber to make it lighter

What throw out bearing your using??

What did you use for the throw out bearing??

What black paint did you use for the trim ?

What'd you pay for insurance? What company? How's the gas on Ontario roads?

Not step by step so many steps missed that I’m clearly finding out doing mine

10 or 10k resistor?

after you change, you were not having problems with the bleeding and burp?

thank you man . thank you youtube . I m from saudi arabia . huge thank like the sky to you bro .

Guys im disabled boy please support me im try to get 200 in 10 days.

Is a dirty gte head.. but tried this method.. sent the locks a hundred foot somewhere…. Now i gotta pay 20$ for a single lock.. dangit.. why are they so damn expensive?

why didn't you change the headgasket?

Got my ac working but touch screen unresponsive

This has to be edited. Going on 3 hours and still cant get it in. I wish you would not speed up the video during the crucial window install

Nice video guys 🎉

Thanks, I needed this.

does it come off on your clothes?

Just got one of these, have a bunch of other JZ chassis but wanted a practical one for the family haha