Video

*Is there anything other than THE BLADE & THE BOLT* that goes on each Blade Drive with the Z4800? No Washers or anything? I've done my blades probably 50 times over the last 3 years & we're approaching Sledgehammer time (today/tomorrow). Schemetics are USELESS. Parts Dicks are USELESS. Manual is USELESS. I'm USELESS. lol

I have one sitting on the wall, theyll drive ya insane..

I have the same balancer as you do, I took my balancer to my JD dealership, we checked 7 brand new blades out of the box, every blade showed unbalanced.

watched this video like 🙃

Dale @5:59 pass the wrench to Blake, he is the one who will probably decide if you go into a nursing home one day Blake great eye, you are correct at 7:28 when you notice the jack "shakes". There is a flaw design of these jacks in that the outer mounting tube has too much slack around the inner lift tube. This causes the jack to wobble if you shake the trailer when the jack is fully extended. As I recall the original design did not have this problem, because it was constructed with square tubing. The original inventor of this jack let the patent run out and the current manufacturer decided to make a cheap knockoff (but that is another story) . Continue to keep your eyes open and notice the little details and you will have the opportunity to teach your dad a lot in the future.

Dude I can’t see a damn thing you’re doing

Why is nobody talking about the video being upside down lol. I thought it was going to be a bit where at somepoint you would flip the camera when the thing was balanced or something

Just replaced my old toro with a honda hrx 217 hya. I love this mower this thing cuts tall grass without stalling, but I hate the price $719 from homedeot is where I picked this mower up 5 years ago.

Would having an air purifier suffice vs cracking a window?

It's that a special type of washer on the drain plug i lost mine

I started using the hrx 217 hya when I was 10 back in 2019. I've had it for 5 years and it works great even though it was cold.

It doesn't work on any battery. Lithium battery - it doesn't work on Lithium battery.

If it is used for vacuum be sure to add the Shredder Blade or you will damage the Impeller. Stihl Part # ST 4229 768 0300 around $12.00 protects from sticks and shreds them. Otherwise, it's a great unit.

Can you film this outside in the daylight?

Kudos for letting your son help. He'll always remember this!!

He's either drunk or stoned but I still watched the video because even someone cross faded can still use this heater and that works for me because I'm also a piece of shit too..

A better camera angle would be useful dude

All over the place with camara, too fast! Very vague in detail.

Excellent video. Thanks.

I have a 12x16 sun room that I like to use for an "office" (I'm retired though, so no work going on!) This is the first winter I've done this. czcams.com/users/postUgkxl2o1MQU4aMgmFk_cMqer4nH2ptpDEM6h I have 2 x 1500 watt electric heaters that are on schedules in Home Assistant. After less than one month of that, I decided a new solution was needed (electric bill went up quite a bit more than expected). I have a 23,000 btu kerosene heater, so I tried that. It definitely works, too well! It heats the space up quickly, but you really can't turn these types of heater down and have then burn efficiently, so I was always lighting it and putting it out. I decided to try this model, and it is perfect for this application. In the morning at 0600 I turn both electric heaters on and light this heater. Within 30 minutes, it's up to 60 degrees (from 35 to 40F), and within an hour it's at 68F. At that point the electric heaters shut off and pretty much stay off the rest of the day. Fuel consumption is also greatly reduced (as would be expected, given that it's half the size/btu output). I can get 2 x 4 hour burns out of a full tank. I also like having these around as emergency backup heat, this is my third kerosene heater. I wish kerosene was cheaper, but not much you can do about that. I have read that you can use #1 diesel with a bit of alcohol added; not sure if I want to go through all that, although diesel is about 2 bucks a gallon cheaper. More research needed.

It's N0T a "gas"gauge, nor; a "gas" can .....

Good video.. the fuels recommendations were very helpful.. thanks

So it’s just a piece of pvc? Like 1 1/2 “? Thinking of doing mine soon

I never had that much time starting my 100 I'm about 2 or 3 times full choke Audi throttle wide open it'll start term choke off

6 years later, I have a new Tiger Cat II with 24 hours on the clock that won’t start. I came across your video while looking for possible cures. I’ll have a look at the steering hardware installation,too. Thank you for the heads - up.

Go trim graveyards. You'll give away your Black Diamond spools of string. I bought a five lb. spool and gave it away. Stuff is useless...

Any opinions on the Dura heat model over or vs the Dyna Glo model?

Just bought a used one same model....hydros seem weak im hoping it just needs adjustment

How do you store it? It’s a weird shape and i am wondering if you hang it up on a wall or something else

upside down video and the important details are obscured/block from camera angle.

why is this upside down..lol

is the fc71 still working?

is this shit triller yall shit is flipped

You can use small double AA batteries in these heaters if you have the adapters covers to put the double AA batteries into. This will save money on batteries.

Holy shit. That is sensitive. Well it beats a nail in the wall.

To help DDEYP & everyone out with a bit of info regarding Oil. As per the Owners manual, under Section 7, Pg 18. The recommended Oil for the CC524SWE is either 0-30 or 5-30, depending on expected outdoor temps or preference. Also mentioned is Engine oil capacity of 600ml / approx 20 oz. Hope that helps!

We don’t see much in this video

Didn't see you use the screws

Do I need to empty the gas tank first?

I have it . Smells so bad

I need a 6x12

I need a 6x12 please/ how much you it is

Good ol' swisher sweet

Where's Boobins?

You don't have to wait to light it when it's new, if you first pour a little fluid around the top edge of the wick instead of waiting for it to soak up fluid from the bottom. That's what I did when I changed the wick in my old one and it makes it ready light right away.

I'm looking into getting one, but I don't plan on ever burning kerosene in it. Kerosene if over $5 a gallon here. I will be using diesel with Seafoam in it, which burns clean and hotter than kerosene (more BTUs per gallon) and no stinky kerosene fumes.

Ypur video is upside down

Buying one now!

Steven Brule?

Ty just what I needed to know