Video

Cyclon now wont fit flush onto the motor trigger component @ 4:10 🤦🏽‍♂️. Whats going on ?

Why would you NEED to replace this inner filter? Is there some update? Some revised filter design?

Not going very well. 6 screws out & #7 seems to be stripped. I’ve tried latex glove on screwdriver foil not sure what else to try. Super frustrating!

Instead of the cheesy music, maybe provide actual directions?

Why cant I get the inner filter off the handle? I removed 2 screws and can not slide it off. Any ideas?

Thank you 🙏🏼

Purchased your trigger, before removing white cap at 0:50 I tested the trigger with accu and filter - worked fine. So cleaning everything intensely and re-screwing everything worked fine. Keep your trigger for the next problem :)

Very good instructional video. I'd say it's a bit harder than shown. Vac is working again though. Thanks!!!

Can you show how to replace the cord for the hs05 model? Also do you have links on where to order the replacement/ comparable parts?

I purchased the trigger lock too, but no instructions on how to install it?

Thank you for this video. A successful repair.

I need that long skinny t8 driver

Thanks! That helped a lot and saved my V11 from planned obsolescence made by Dyson 😍

I used T8

Hi, do you have alibaba store? I’m Chinese. I wanna directly in contact with you

Thank you very much for the metal trigger and the instructions video. Awesome job all around!

What size torque driver did you use?

Where is the refill of this sold at? The purple part