Video

Hopefully not , what you recon they are in the uk for , that's quite concerning isn't it ?

@buugedy im just being thorough. May not be needed but I prefer to do it that way . Thanks

Thanks so much mate 🤣🤣🤣

Keep up the good work mate💪🤠

@jamiegalletly3782 thanks so much mate

Thanks so much mate 😊

@fredesteki9574 over reaction much 👍 as I've explained quite alot in the comments . That it wasn't intentional . Calm your beans mate I'm only human 🤷‍♂️

Thanks for your positive words mate . Aye man I really gotta get the enthusiasm back and get a decent unit . Far to many bin lids out there 😂😂😂😂

@@autosolutionscheckpoint something decent will come up mate 🤞

​@colingilland3454 I hope so mate , its sending me bat sh1t bonkers 😂😂😂

I dont use a torque wrench myself however I would say the insignia should be about 150nm . Thank you

@@autosolutionscheckpoint ok, gracias, esque tenía duda de los tornillos del porta pinza, porque los tornillos de guía se que son a 30nm, gracias por tu respuesta

Thanks mate much appreciated 👍

Just be careful if your getting it tho , as it also could be turbo or injectors to name a couple. If your buying it and it needs a turbo, I have one on the shelf forn£100. I don't rate these engines at all, one of the worst problems I've seen with them , is a small rubber O ring between the oil pump and the engine goes , O ring is a few pence , but to do the job is very Labour intensive and isn't a straight forward job. It causes the engine to seize up. The 2.0 cdti is a big gamble in my honest opinion. Good luck mate

It's perfectly fine, . I have been doing it this way for nearly 3 decades in the motor trade and never once had the problem you mentioned . Don't get me wrong, this could happen it's slopped on and maybe filled with oil and driven shortly after, this was left empty for a 2 day period for it to cure properly before the oil was put in . Cheers

100% a 1.0 .

Better being different than following the herd of sheep 💪🤠👌, my mother inlaw would love this, her full wardrobe is leopard print 🤣🤣🤣

@@autosolutionscheckpoint I just enjoy watching people looking more at my shitty Porsche than the girlfriends R34 Skyline next to it 😂

@@TheBlakeypoos would rather have German over jap any day, but that's just my preference. I have had a Jap car to flip on my channel , didn't realise how much of a fan base the Toyota esitma had until I got it , i was gonna scrap it too lol🤣🤣🤣🤣🤣

Hi mate , have you 2 batteries under the seat?

No just the 1 battery.

@mickroda3876 sorry for the delay , I was at a classic car show today so was doing alot of filming . Have you tested the volts on your battery? When the battery is idle ,if its good , it is typically around 12.6v . If its a bit less could possibly mean dead cells in your battery and may need changed.Test it while its running and it will frequent between 13.5v and 14.5v of the alternator is doing its job properly. If its higher it will be overcharging and alternator is at fault or if it doesn't have much activity on the reading then it's not getting a charge . Meaning alternator also. , this is where I would start, by checking the battery and how its charging

Yeah it had a new alternator about 4 months ago. Just tested it on idle and it's kicking 14.5v

@mickroda3876 maybe a fueling issue 🤔 has it been plugged in recently, how long have you been experiencing this problem? Fuel filter been changed?

Yes you are right however the plug has a rubber coating seal to repair it from leaks . Very effective 👌

Hi mate , yes I sure do, it's actually booked in this morning to get moted again. Awh thats a Shame about the one you have . What is your plans with it? Could still be a good source of parts to breath life into other cavaliers . Great wee cars and so nostalgic. My dad always had them when I was wee , he always had sri hatchback ones . I've had the chance of another convertible cavalier for 200 but it's down the other side of London so would cost about 6 billion quid in diesel to collect it 🤣🤣

Could only watch 3 mins of this

Yes , it's engine oil mate . This one was mental , it was like a cut vain when the engine was running. It was spraying onto the fan belt sending the oil everywhere. It was a complete nightmare

Thanks mate 💪🤠👌

The Nissan Elgrand Owners Club is pretty helpful. There are Japanese parts importers. For example, JDM CAR PARTS UK LTD. EDIT: Not sponsored by JDM car parts or had business with them.

Aye mate she moves like . 💩of a shovel 🤣

Thanks so much mate , aye rub it in lol. Wish I had a warm excavator. I'd more than likely end up on the 6 o'clock news. I'd be our wrecking the place 🤣🤣🤣🤣🤣

Thank you so much baji ❤️

Totally. My loyalty lays with l200. Such a fun pickup . Thanks very much for your kind words lesley. Stay safe and take care x