Video

Great video tutorial and Keep em Rolling!

👍

That was extremely helpful! Thanks for sharing

Link for new motor replacement? Is this the 16HP or the 18HP?

*promosm* ☝️

At the price of new mower I see a lot of new engine will be installed this year

Your video came in handy. I'm doing an engine swap this April. I love your shop and the lift that you are using is "bad to the bone". It would make the job a lot easier on tall old guys like me... LOL 😆.I hope the clutch that I'm dealing with comes off a lot easier... but more than likely it will not... Thanks for the video.

I used a combination of pry bars. Lady's foot, 12" standard along with some pin point heat where safe. It took about 30 min why not in video.

What kind of "persuasion" did you use on the clutch? I'll be replacing the Intek on my Deere Z-trak in a couple of months. I have everything set in my mind on how to do it, except how I'll handle it if the clutch is seized on the shaft.

Merry Christmas Be safe winter is here again

I'm wondering if yinz do warning light installs regularly? Why I ask is it seems as though the front light was mounted in a matter that really would only alert air traffic. It should have been mounted in a way that it face forward on a level plain. Then the light you installed on the rear. The lift light looks to be vertically straight up & down and the left definitely not. If this was your own mower it would be fine because as long as you don't care about these things whatever. But if you were doing this for a customer I'd bet they will not be a repeat customer.

So how well did it work?