- 13
- 1 462 529
ClassicBond EPDM
Registrace 5. 11. 2013
Video
ClassicBond ® Pipe Seal Installation
zhlédnutí 28KPřed 10 lety
How to install ClassicBond EPDM around a vertical pipe using the pipe seal accessory.
ClassicBond ® EPDM Pipe Wrap Installation
zhlédnutí 38KPřed 10 lety
Installation of ClassicBond EPDM around a vertical pipe using the pipe wrap method.
ClassicBond ® EPDM Internal Corner Installation
zhlédnutí 59KPřed 10 lety
How to install ClassicBond EPDM to an internal roof corner
ClassicBond ® EPDM External Corner Installation
zhlédnutí 129KPřed 10 lety
How to install ClassicBond EPDM to and external roof corner.
Installing ClassicBond ® EPDM Pipe Box Pocket Using Pourable Sealer
zhlédnutí 7KPřed 10 lety
How to install the ClassicBond EPDM around a vertical pipe using a pipe box pocket and pourable sealer
Installing ClassicBond ® EPDM and Sure Edge to Upstand
zhlédnutí 91KPřed 10 lety
How to install the ClassicBond EPDM Membrane to a flat roof with an upstand.
Full Installation of ClassicBond ® EPDM roof with Sure Edge ® Trims
zhlédnutí 1MPřed 10 lety
Complete installation of a ClassicBond EPDM roofing system with and SureEdge roof trim system to a flat roof.
Installing ClassicBond ® EPDM to Upstand with RUSS
zhlédnutí 31KPřed 10 lety
How to install ClassicBond EPDM with SureEdge trim to a roof with an upstand using RUSS to secure the EPDM membrane.
Installing ClassicBond ® EPDM To A Roof With A Seam
zhlédnutí 17KPřed 10 lety
How to install ClassicBond EPDM to a roof that requires a seam.
Does the felt adhesive stick to a brick wall just as good as osb?
No lap adhesive caulk?
How do you join two lengths of this overlapped side by side?
This is joined using the pre applied seam tape that runs down the length of the roll. Apply ClassicBond Pro Primer to the corresponding sheet, allow to cure then put the two together. This can be seen at czcams.com/video/zrGAxDLHqnQ/video.html
Does this work when sticking to brick? Not osb?
Can you slow down your captions, they’re gone before I can read them!
This is a very informative tutorial
Very informative, thank you.
Will hopefully be doing this in a few weeks' time. Pipe is too close to the wall to take a pre-made seal (witches' hat) so I'll have to wrap it.