![MyTrick RC](/img/default-banner.jpg)
- 97
- 1 006 992
MyTrick RC
Registrace 10. 03. 2012
MyTrickRC ARRMA Felony Deluxe Light Kit.
MyTrickRC ARRMA Felony Deluxe Light Kit. With functioning Tail/Brake Lights, Reverse, and Backfire
zhlédnutí: 437
Video
EZ Splitter
zhlédnutí 475Před 2 lety
This video shows how to use out new EZ Splitter to install LEDs. This allows you to use a much smaller hole in the body or your custom 3D printed light bucket.
S4 POD Assembly
zhlédnutí 533Před 2 lety
This is an assembly video for our super versatile S4 PODs. They can be use for ditch lights, roof lights, light bar, roof rack, trailer, anywhere you will like more visibility.
Axial Early Bronco Light Kit Installation
zhlédnutí 1,8KPřed 2 lety
This video goes over how we laid out our light kit for the Axial Early Bronco. The kit is expandable to add even more lights.
RC4WD Xtracab Light Kit Installation
zhlédnutí 1,3KPřed 2 lety
When installing this kit be sure to exactly copy the cable routing under the engine bay its a tight fit but it clears.
Attack S4 LED POD Assembly
zhlédnutí 219Před 2 lety
This video goes over how to assemble your S4 light pod that comes in our Gatekeeper light kit.
Axial RR10 Bomber Light Kit Installation
zhlédnutí 1,5KPřed 2 lety
This is an install video for out light kit designed for the Axial RR10 Bomber.
Axial Deadbolt Light Kit Installation
zhlédnutí 2,1KPřed 2 lety
This is a short installation video of our light kit for the Axial Deadbolt.
Element Knightrunner Light kit Installation
zhlédnutí 4,9KPřed 2 lety
In this video we go over the installation of all the lighting on the Element Knightrunner. How to assemble Attack Rock Lights and lay out your wiring.
Element Gatekeeper Attack Light Kit Installation
zhlédnutí 1,5KPřed 2 lety
This video is a instructional for installing the MytrickRC Attack Light kit onto your Element Gatekeeper.
MyTrickRC Emergency Lighting for RC vehicles
zhlédnutí 1,4KPřed 2 lety
MyTrickRC Emergency Lighting for RC vehicles
MyTrickRC Light Kit for Traxxas Sport RTR
zhlédnutí 414Před 2 lety
MyTrickRC Light Kit for Traxxas Sport RTR
Traxxas TRX 4 Defender 5in light bar install
zhlédnutí 1,4KPřed 4 lety
Traxxas TRX 4 Defender 5in light bar install
MyTrickRC SCX10iii Rubicon Deluxe Light Kit Installation
zhlédnutí 15KPřed 4 lety
MyTrickRC SCX10iii Rubicon Deluxe Light Kit Installation
MyTrickRC Traxxas Bronco Light Kit Install
zhlédnutí 12KPřed 5 lety
MyTrickRC Traxxas Bronco Light Kit Install
MyTrickRC Axial Blazer Light Kit Install
zhlédnutí 4,6KPřed 5 lety
MyTrickRC Axial Blazer Light Kit Install
MyTrickRC Axial 2017 Wrangler Light Kit Install
zhlédnutí 6KPřed 6 lety
MyTrickRC Axial 2017 Wrangler Light Kit Install
Yaaaa
Where can I buy the light bar bracets
Good stuff....very thorough and clear. Thanks....more pls
Awesomness
No light installation 😢just music and update what truck gone through.... did not like this video .....
You failed to show all the modes while the plane is on the table
this controller work on 3s battery no harm on LED lights?thanks
What about the brake light
Wats not water proof in that kit?
Are the lights on all the time?
Where do you plug it in?
What is the kit part number.?? please and thank you 🙏
Will there be a new controller to match DG-1? Wire broke on mine. I Like how can use 3rd channel to turn on off
Can the brake light function be programmed to stay on while the throttle is in neutral for aplication into a crawler with a drag brake?
I just purched this flasher for my Tamiya Agrios monster truck. I have a question(s)about mounting this flasher. How did you fit the mode button located at the bottom of the flasher? Did you make the center big enough to fit both the wire and button?
Where do you get the l.e.d bezels that snap into the hole made ?
Answer your god damn emails. My order is missing parts and doesn’t even work as advertised. You guys suck.
You guys suck ass. I’ve been trying to message you with questions and nothing.
Are they waterproof?
can you take a picture of what you used to run the lights to connect to ? I have the HB-2 brain can the DG1 power block be used
Link to the bumper light bar?
Why does it connect to the Throttl channel? and not just a spare port? If I plug into a spare port will an aux channel turn them on and of or do I ned a seperate Switch?
a lot of these lights have 3 wires does it work with only a positive and negative ?
@MyTrick RC Any ebay link to the board you are pluging in the lights too which is in the middle of the underside of the bodyshell ?
How can I find this light kit 1-3-2023 .
Nice concept
what magnetic body mount kit did you guys use for this rig
Why use magnets when it's already drilled..... Magnets are for bodies without holes :p unless they patched it with an accessory
@@slottygw2wvw842 😀😀😀😀
How can I get the yellow lights in the back?
I’m having a problem with my controller. My mode 5 has flaring lights. Mode 6 and 7 seem to be the street car mode but the brake lights don’t work when on the brakes or in reverse. They are just on continuously. I have them in B port and I have tried them on mode 6 and 7 (as well as mode 5 per the video. I’m sure I have the UF-7 and not the UF-7C as I have went through every manual and video I can find and still no solution. PLEASE HELP!! Thanks in advance!!
I am assuming your body is mounted via magnet
Wair did you by police light bar from?
Wo bekommt man die Steuerung?
Those are slick! I ordered a set for my Ryft and my Capra.
Where did you get the lights?
@@Jonny_apple_seed MyTrickRC
The stock chevy C10 comes with headlight buckets…
Yes but the headlights are in the bumper the added break and headlights add alot
Where can buy this
Can you please give me the link for this item 🙏
Where did you plug the two wires did you plug them in the ecu and the receiver?
this is the worst install video ever.... where does everything get plugged into? how do you wire all the items....why did you just stop the video??
Awesome video 👍👍🔥🔥💯💪💪👊🏼👊🏼🤙🤙
My reverse light it not switching off fully? Any tips? I have tried to redo throttle calibration but no luck.
What is the part number for this light kit?
1:09 ...was very helpful when i put the power cable in *upside down*. "...it's in right por...oh, wait..." 🤪
This kit is really well thought out and installs easily! I used Tamiya's Polycarbonate Body Cleaner to get the paint off behind the rear light stickers.
Where did you mount the DG-1 controller? There are lights attached to both the body of the rc as well as the chassis. So did you mount the DG-1 on the chassis and just disconnect the front and rear bucket lights when you want to work on it or did you mount it in the body and disconnect the light bars?
We have the controller mounted to the body on the driver inside door.
where do you have these lights from
The lights and buckets are on our website
Just installed this great kit was easy. will it run off auxiliary and third channel on and off
What kit is it in the website
I can’t find a price on the lights
Can you send me one
Pls could you tell where can I get one of these kits?
mytrickrc.com/products/element-knight-runner-light-kit?_pos=2&_sid=aa95b70e2&_ss=r