puzon343
puzon343
  • 10
  • 502 321

Video

How to remove battery and fuse box Peugeot 508
zhlédnutí 218KPřed 6 lety
Please subscribe and don't forget to like the video if you found it helpful. Any questions are welcome.
Peugeot 508 cold start
zhlédnutí 3,8KPřed 6 lety
Mildly cold start
The (un)expected Peugeot 508 repair
zhlédnutí 17KPřed 6 lety
Please subscribe and don't forget to like the video if you found it helpful. Any questions are welcome.
How to reset service / maintenance light (spanner) Peugeot 508
zhlédnutí 2,6KPřed 6 lety
Please subscribe for more videos.
How to change oil and oil filter on Peugeot 508 1.6 e-HDI
zhlédnutí 41KPřed 6 lety
Oil sump socket size - 21 Oil filter cap socket size - 27 Oil used - Total Quartz Ineo ECS 5W30 Synthetic After an unsuccessful attempt to change the oil the day earlier I had decided to relax and give it to a professional mechanic.
How to replace / change pollen cabin filter Peugeot 508
zhlédnutí 51KPřed 6 lety
Quick video on how to replace the cabin filter.
How to replace / change an air filter on a Peugeot 508 1.6 e-HDI
zhlédnutí 25KPřed 6 lety
Quick video on how to change an air filter on a Peugeot 508 1.6 e-HDI. More to come.
How to replace / change rear brake pads Peugeot 508 with electronic handbrake / parking brake
zhlédnutí 79KPřed 6 lety
DIY video on changing rear brake pads Peugeot 508

Komentáře

  • @TelefonųNaujienos
    @TelefonųNaujienos Před měsícem

    Why you first removed + and then -? That it is wrong.

  • @rabarbaras8
    @rabarbaras8 Před měsícem

    Why u first removed + and then -?

  • @Gmailisshit
    @Gmailisshit Před 2 měsíci

    These cars are absolute dog shit

  • @Sonata-king-of-repair
    @Sonata-king-of-repair Před 4 měsíci

    안녕하세요 램프 교환 정말 어렵네요

  • @PaulP999
    @PaulP999 Před 5 měsíci

    About the sump drain plug, a good old real money 13/16" socket fits just right. I've just come in from doing this and I assumed the filter went on first to engage that peg and that the body screws down on it to engage ok - hope I'm right 'cos I ain't taking it all off again! I ha to also tie back the smaller hose above the filter body and luckily had a 27mm socket because the whole body is plastic so attempts with anything other than a snug socket tends to bugger up the soft hex which is also part of the body. I also unnecessarily took off the big underside plastic panel because someone said you had to, should have looked closer first and seen the sump plug.

  • @floridahummer
    @floridahummer Před 6 měsíci

    hi, i removed the nut covered by the orange tape, after reconnecting it the car wont start and the lights wont come on, if that just a blown fuse or have I done something to the computer? many thanks

  • @AugmentedGravity
    @AugmentedGravity Před 6 měsíci

    What model? Year?

  • @MrNmc09331
    @MrNmc09331 Před 7 měsíci

    Your video saved my weekend :-)

  • @user-mf7wf5ie9k
    @user-mf7wf5ie9k Před 11 měsíci

    Idiot

  • @AugmentedGravity
    @AugmentedGravity Před 11 měsíci

    Is there a difference of pads between electronic and non electronic handbrakes?

  • @leedaniels1468
    @leedaniels1468 Před rokem

    😅😅😅😅

  • @MrRGM10
    @MrRGM10 Před rokem

    Do you know what you call the special tool and size to remove brake caliper

  • @frankietan3132
    @frankietan3132 Před rokem

    For fuse F26 where is located

  • @mrconta
    @mrconta Před rokem

    I did this but it still light up? what is wrong

  • @timmaher4541
    @timmaher4541 Před rokem

    Fuse box seperates from the battery surround box and U remove each one separately

  • @timmaher4541
    @timmaher4541 Před rokem

    This is the wrong way to do this and can damage the fuse box. The orange tape is there for a reason

    • @floridahummer
      @floridahummer Před 6 měsíci

      i removed to nut that is taped over and I reconected the battery it wont start, I get one click, is there anything I can do to fix it?

    • @muhammadshahzaibshams4684
      @muhammadshahzaibshams4684 Před 3 měsíci

      I am just having the same issue. When i get the positive connector it just doesnt take it.. rather it give a spark spatter​.. @floridahummer.. just a recap, I had removed the battery out last year in November to do the top end.. but wasn't able to finish until now. Now I have it ready with battery in but it just doesn't like it. Any tips ?

  • @GaUsMaNiAk
    @GaUsMaNiAk Před rokem

    Check the 508 user manual in German, page 259, if you won't break off any clips. You have to remove the clip on the top (7) and the clip on the left (8) and push the cable unit (9) away, before you lose all the other clips of the cover (10). It is not necessary to unscrew the sealed nut btw. As you can see the top clip (7) broke off in the video. Same happened to me because I didn't follow the user manual instructions first.

  • @adislfc
    @adislfc Před rokem

    I have this problem "electrical circuit fault have the vehicle repaired" Do you know what could it be? I have new battery instaled.

  • @maikomeier1393
    @maikomeier1393 Před rokem

    Hello, what is the metal clip, 4:32 min ?

  • @user-skladovskaya_Nastya

    Ничего не понятно , но очень познавательно... Теперь ясно почему у вас так много рабочих мест... Особенно интересно как левая лампа раскуроченна 🤣

  • @csababodo2509
    @csababodo2509 Před rokem

    Thank You!!

  • @slawomirczarnotta9662

    Zgxhcjchv

  • @slawomirczarnotta9662

    Czbxjxjxhcb

  • @kings3955
    @kings3955 Před rokem

    Well done! Thank you

  • @odelkuk
    @odelkuk Před 2 lety

    Crazy construction just for a bulb

  • @ondrejsevcik6440
    @ondrejsevcik6440 Před 2 lety

    Thank you. Works on 308 T9 :)

  • @steffenc77
    @steffenc77 Před 2 lety

    Thank you wery much mate...

  • @diezasd7756
    @diezasd7756 Před 2 lety

    Is there any high pitch noise coming from the dashboard in ur car?

  • @iulianbarza6698
    @iulianbarza6698 Před 2 lety

    Thank you! Nice video !

  • @ryuhollande4267
    @ryuhollande4267 Před 2 lety

    merci pour la video meme si langle de camera on voit pas tous bien en detail. un tuto pour changer l'ampoule côté conducteur sans demonter batterie??

  • @impaelas
    @impaelas Před 2 lety

    How do you "just start ignition" without starting the engine? Gear lever on N and Start/Stop button? Can you please clarify?

    • @raczattila6795
      @raczattila6795 Před 2 lety

      dont push the brake pedal while pushing the button

  • @XORExploite
    @XORExploite Před 2 lety

    danx, you helped me :)

  • @fernandostanic2035
    @fernandostanic2035 Před 2 lety

    I have a problem with same car. When im driving and realese throtle (gas pedal) car jerks onece or twice and then it goes with normal engine breaking. I have allready changed all engine and gearbox mounts and dual mass flywhell with clutch and realese bearing. All other on car is in perfect contition DPF is new, and injectors are like new.

  • @gravitygalax1653
    @gravitygalax1653 Před 3 lety

    Worst video ever.

  • @magedmounir3564
    @magedmounir3564 Před 3 lety

    Many thanks for the great help.

  • @lucianpopescu5719
    @lucianpopescu5719 Před 3 lety

    Don't you have to rewind the caliper from a obd scanner on a electric brakes ?

    • @AugmentedGravity
      @AugmentedGravity Před 11 měsíci

      I was told this by a mechanic

    • @mochanicc
      @mochanicc Před 26 dny

      Yes you have to however some cars have manual override but this video is wrongly titled. There is no mention of electrical handbrake 😊

  • @duskobogos2348
    @duskobogos2348 Před 3 lety

    wholly CRAP!!!!

  • @fernandostanic2035
    @fernandostanic2035 Před 3 lety

    On my 508 with xenon i have poor visiblity in rain. Blubs seem good but ligth cutoff and spread its not god on road. Can projecotrs been cleaned?

    • @melon5544
      @melon5544 Před 3 lety

      Hi. Did You found out if projectors can be cleaned/replaced? I also have very poor efficiency in one of headlights and bulbs were already changed

  • @someoneinsweden3
    @someoneinsweden3 Před 3 lety

    Thank you

  • @someoneinsweden3
    @someoneinsweden3 Před 3 lety

    Hey man. On my peugeot The handbrake goes in when i turn my var off? How do o let it free so The disc spin like yours?

    • @puzon343
      @puzon343 Před 3 lety

      Hi, I actually made a video on how to do exactly that. Please see one of my comments under this video for a link

  • @Worship_Praise23
    @Worship_Praise23 Před 3 lety

    Please can you share a video of how to change Transmission fluid in Peugeot 508 1.6

  • @cirodimarzio2775
    @cirodimarzio2775 Před 3 lety

    After i do the same work like you my assistent lights stop works...in night does not change the long distance lights with the shorts...?Why is that?

  • @davidpremontini2858
    @davidpremontini2858 Před 3 lety

    hero!

  • @illesjuraj
    @illesjuraj Před 3 lety

    Pekné. Šecek bordel co ten filter odfiltroval aj tak napada dovnutra auta. Haha

  • @qasimrabbani3042
    @qasimrabbani3042 Před 4 lety

    What model 508? Da

  • @monkehbitch
    @monkehbitch Před 4 lety

    The fannying around twisting the piston with pliers is no good, get yourself a proper windback kit. You'd have it done in half the time. Good effort though at least showing that is capable without the windback tool. You should've at least removed the caliper carrier too, to grease up.

  • @monkehbitch
    @monkehbitch Před 4 lety

    Using a torx but for hex socket??

  • @anisboulahia1717
    @anisboulahia1717 Před 4 lety

    Attention, il faut savoir que le retrait de la batterie provoquera une perte de la programmation de certaines options sur la voiture récente. Faites attention !!!

  • @ouzaloid
    @ouzaloid Před 4 lety

    We don't see what you are doing

  • @johngreen7786
    @johngreen7786 Před 4 lety

    Just happened to me at 37k. What a poor design peugeot.