Video

That's a nice video mate 😅

great video mate thx u

If it possible to convert that corring drill to press drill

25 years later he opened the hole 😂

Thank you so much! Couldn’t find any other video that talked about this

I'm curious to know how you removed that rod you glued in the wall.

What is this hole for ? Underground electrical service?

How much was it to hire that beast buddy?

How long did it take you .

Careful. They might think you were on the Hatton Garden job.

Well done I was very sceptical at the start of the video but what you did was really good

how thick was the wall in your video?

This was helpful, thank you. Just considering if I should rent similar machine or get a pro to do the job.

Thanks for the very helpful video. I have a very similar wall to core except I wish to drill down at 45 degrees from the inside. Roughly how long did it take you once you starting coring?

thanks for showing your hole at the end very educational

Thanks for sharing 😀

3:03 Those are rebars?

Nice job. What kind of bunce we talking for hiring a beast like that?

Great thanks very much 😁

Don't kill yourself man . I do that with one hand 😉 Save energy. We work hard anyway so why not ? czcams.com/users/shortsPoKdPNQkAq4?feature=share

I am guessing your Core Hole did not have to be precise?

At least your usin a good machine....but on that soft wall I would bolt thru for mounting....good vid👍🇺🇸

Great video

good job, i like that guide attachment

Thanks for the vid, we have a similar drill in work using a cup with the same diameter but a smaller depth. It has a pilot bit in the middle which we line up with the pre-drilled pilot hole. We don't use a stand to hold the drill so no need to insert threaded bar in the wall to hold it. We line up the drill, hold it straight and steady, put a bit of pressure and let it do the work. It has a small level on the top of the body to tell you you're level. If you get your house insulated and need to put vents in each room, our way might be a less time consuming less expensive way of doing it.

Great video, i really enjoyed that. Thinking about buying one of these for my work

Incredible. Where did you hire the drill and column?