Video

Wiring Diagram??

This makes me wanna work on Harley’s now

Will the 07-13 superstreet exhaust fit 14-20 sportsters?

Which one is louder Between S&S (without Db reducers) or Vance and Hines slip ons?

It's about to be the sportster. They are fastest hell from the line.

Bought a 05 fatboy. The second time I took it out, the shifter would not return anymore. Thinking I may attempt this.

So good they don’t produce them anymore?

can i keep the clutch cable on that bars if i just need to replace the o ring from where the side cover and cable meet? will i need to loosen the clutch cable beforehand?

Thank you so much, I was trying to clean the grime from under the clip when the nut dropped out. I was thinking I was screwed until I found this video. Thanks again 🙏

Thanks bro great information👍

if you upgrade to a 6 piston caliper do you have to install larger master cylinder

Awesome video for the average Joe learning to work on these bikes. Very helpful thanks!

Do I need this extra tool if I'm just flushing the system and don't introduce any air? I don't need to extend brake lines or anything like that, just a standard flush. I would think that wouldn't require ABS actuation if I'm not flushing air out of the system.

Rich kids think she's so he says remove the damper spring and see if they're still there except he doesn't tell you what to do if they are there and he sure doesn't tell you put it back in you know what he's good at his own head send it back to his fucking garage and tell him goodbye do not watch this kids videos

Can I run a front directional on the rear? I bought two exact same tire sizes as my bike has now. But both say ROTATION:FRONT ... just curious. Thank you😊

he says "dampening" 💦 lol...

Use same brake pads or is there a different style?

What do you mean by 39mm front end .Where does that number come from.

Back in 2005 ape hanger were illegal. Handbars couldn't be higher than shoulder. A couple cops helped me adjust them down. Good guys.

My sporty has sat for a while, half stripped down and i was going to drain the oil before pulling the oil tank and motor out for a frame chop, and noticed my tank was pretty light and empty. I was thinking it must be why they say to run the bike first. But how do you drain it if you cant run the bike?? Does the bolt on the bottom of the primary work on a sporty for that?

Would the sportster starter be somewhat the same deal ?

What if can't get your harley to start

so how bout us late model guys?

wasted that beautiful frame on that monstrosity build

Love this. Have not camped yet but its on my list and this video was helpful

question you said the lines for injector that Mark to the front and to the rear I just bought that FG 2000 black and is no difference and no marks. I’m end of the line going to injectors.

How it is in rain off/on road?

My Harley XR1200 was a good touring machine once you lowered the pegs and got a more comfortable aftermarket seat. A rear rack for a small duffle and a tank bag is all I needed for a week. Carry an MSR Liter bottle of fuel for an extra 10-15 mile safety factor in case you run out with that small tank...

so i dont need to open the Transmission Cover.... saves cost for the Cover sealing

It's pathetic that you have to buy those in the first place

I am so overwhelmed on the amount of options for aftermarket air intakes where do I begin? That would be a great fit for my 2023 street Bob 114

Merci 👌👍👍👍👍👍

Love the commitment of demonstrating the net 😂

Thank you so much. You just saved me a ton of time. I appreciate it.

Please, it looked like you had and inch and a quarter play at the end there? Am I not reading this right?

Dam right 😊

Anyone know if you can reuse the stock TC 103 pushrods with the SE 204 Cams?

So I was going to fix my 02 sensor but now I’m like wtf there is more to this

Are the fatter tires more safer than the skinny ones?

See everything Arlen Ness has to offer! bit.ly/3VVwNtf

Not trying to be that guy either but you had a great video. I love it. But however, when you start to say around 815, don’t lose that clip does it go over or under the circle clip on the needle there’s some details here that everybody I think is watching the video for and you’re talking about every other thing but I think whatever everybody wants to know then you don’t have it on there right away, it’s been cut. I get it I get it.

Thanks so much for the video! I've only been riding for 2 years, but been a shade tree mechanic since I couldn't afford to pay anybody to do my work since college. 😅 This is my first maintenance on my 2010 Harley Davidson Street Glide. Great to have you guys hanging out in the garage with me helping me do it for the first time.

Where's the tank and fender cover

I'm guessing there is a massive profit maqrgin on Legend suspension because it's the worst suspension I've ever seen. Incredibly harsh ride and the stock suspension is so much better for street riders. If an upgrade is wanted I highly recommend Wilbers. I wouldn't use legends if you gave it to me.

I have a set of these set up on my golf cart but there is a high pitch noise that my wife can hear. I have them hooked up to a 12 volt powered buss bar. The bus bar is powered from a 48volt to 12 volt reducer which is powered on once the power is turned on the golf cart. Any advice on how to get rid of the high pitched noise?

I sure as heck don't have that kinda money. But, I can make a breather kit!

Thanks really great information and you made it easy. Cheers!

Added bars to my new RGL. Replaced the clutch cable with the plastic spring adjuster to older style clutch cable with locknut. May be old video but it is still good. Thx

Good video, especially considering I usually don't like your videos.

Talking twin cams...These are the #1 slipons for touring bikes. #1 for any twin cam bike is the SE2, for the low rider. mm mm mm.