![Matt Shaughnessy](/img/default-banner.jpg)
- 617
- 9 089 138
Matt Shaughnessy
Registrace 20. 05. 2013
This channel will have mainly automotive diagnostic and repair videos. It will also have a few of my cooking videos and recipes.
how to pull vacuum on your auto A/C
this video will show the simple way and reason for pulling a vacuum on your new A/C system.
zhlédnutí: 284
Video
Honda Accord A/C compressor removal
zhlédnutí 107Před 14 dny
this video will show you how to remove a Honda Accord A/C compressor.
2009 Honda Accord A/C condenser removal and replacement.
zhlédnutí 116Před 14 dny
this video will show you a step-by-step how to replace your AC condenser on your 2009 Honda Accord along with some tips and tricks.
Visual automotive inspection
zhlédnutí 76Před 14 dny
this video will give you some good information on how I perform a visual automotive inspection
Honda Accord A/C diagnose
zhlédnutí 39Před 14 dny
I found the passenger side fan not working properly along with AC compressor that is burnt up.
finished Honda engine replacement
zhlédnutí 51Před 21 dnem
I finally finished this Honda engine replacement! thanks for watching!
Mercury 200 outboard carburetor removal
zhlédnutí 85Před 28 dny
moving forward with the carb service on this ole mercury outboard.
Mercury outboard air box removal
zhlédnutí 63Před 28 dny
working on this Old Mercury outboard engine pulling the airbox getting ready to pull the carburetors for cleaning this video has all kinds of good information for you. thanks for watching and don't forget to subscribe!
Honda 1.7 l engine replacement finished.
zhlédnutí 71Před 28 dny
this was a heavy job more than I expected and I still have some bugs to work out. there is some good information in this video. thanks for watching.
Mercury 200 carb clean and tune up information part 1
zhlédnutí 87Před měsícem
I found this one Mercury 200 to work on and have fun with. I'm going to remove the carbs and clean them and tune it up.
Ford F150 blinkers not working with tilt steering information
zhlédnutí 72Před měsícem
do your blinkers only work when your steering wheel is tilted into a certain position on your Ford F-150? if so this could be why.
Honda 1.7l engine how to replace water pump and timing belt.
zhlédnutí 105Před 3 měsíci
this video will show you how to replace the timing belt, tensioner, and water pump on a Honda 1.7l engine.
Honda 1.7l how to set the engine to replace the timing belt.
zhlédnutí 93Před 3 měsíci
this video will show you how to set the top dead center on a Honda 1.7l engine to replace the timing belt and water pump.
Honda ACTY inner wheel bearing removal and replacement
zhlédnutí 206Před 3 měsíci
this is how I replaced the inner wheel bearings on a Honda ACTY
how to remove Honda crankshaft bolt
zhlédnutí 186Před 3 měsíci
some Hondas have a really stubborn crankshaft bolt. sometimes you need a special socket and an impact gun to get it loose. Link For tool: amzn.to/3Ixr8SF
how to remove and replace valve cover gasket honda 1.7l engine
zhlédnutí 99Před 4 měsíci
how to remove and replace valve cover gasket honda 1.7l engine
how to replace ignition coils and spark plugs on a Honda 1.7l engine
zhlédnutí 59Před 4 měsíci
how to replace ignition coils and spark plugs on a Honda 1.7l engine
1996 Acura stage 2 tune and custom build.
zhlédnutí 89Před 4 měsíci
1996 Acura stage 2 tune and custom build.
1996 Acura Integra camshaft install/cap tourqe specs/cam cap bolt strips out!
zhlédnutí 218Před 7 měsíci
1996 Acura Integra camshaft install/cap tourqe specs/cam cap bolt strips out!
Acura B1B cylinder head torque specifications
zhlédnutí 73Před 7 měsíci
Acura B1B cylinder head torque specifications
GMC 6.0l stage 2 rebuild crank shaft torque sequence.
zhlédnutí 81Před 7 měsíci
GMC 6.0l stage 2 rebuild crank shaft torque sequence.
BMW 335i Brake light issues after A/C and tune up services.
zhlédnutí 78Před 7 měsíci
BMW 335i Brake light issues after A/C and tune up services.
2012 Subaru Impreza oil to coolant contamination
zhlédnutí 2,2KPřed 8 měsíci
2012 Subaru Impreza oil to coolant contamination
2006 dodge Cummins bad parts out of the box.
zhlédnutí 141Před 10 měsíci
2006 dodge Cummins bad parts out of the box.
So what about the oil pump?
Thank you for the video brother Edit*if you see this if I just damaged the condenser should I replace the compressor too?
I would. I have to many come backs and issues not replacing the whole system. also I've learned if you replace the whole system every thing is now under parts warranty and if there is an issue in the future you can figure it out easily.
Its a good way to get the guy to buy a new Grand Wagoner SUV
Hey have you come across a engine noise under valve cover on a 2007 vue v6
Prolly don’t sound like a cam phaser because it doesn’t have any…nah that can’t be it…smh..🙄
Freaking so expensive to do freeon recharge at toyota here in Vancouver Canada, almost 400 dollars . Is it normal?
Any tips for removing the top two bellhouse bolts on a 2006 durango with a 4.7l with 4wd? The stupid transmission harness runs directly in front of the two bolts blocking me from getting them. Any help I’d appreciate
Hello, if you happen to see this how did you go about removing the crankshaft nut and pulley
It's the thermal expansion valve. That is the part it's leaking from the part costs between $25-$75 depending on manufacturer. It takes a few minutes to change then add freeon no need to add PAG because the was likely too much added in the first place to make the valve fail.
I'm needing to know the math on how to adjust the valves etc. on my 97 Toyota corolla 1.6 liter
Hi how are you my racking pinion mount broke into the frame how can I get the broke bolt out
Hey i beleieve i am having the same problem. So with the temp sensor being coated with that slime not having the temp gauges illuminate. Should the radiator still gurle into the reservoir of its overheating??
@MattShaughnessy6 can i do this without taking the whole side timing chain cover off, is it possible with just taking off the small tensioner cover at the bottom?
Nice video
Would love to talk to you
I put my Tracker 03 ' 2.5 engine, together with ur vidio; i need to ask you a guestion about the oil being sucked into rearanifold and out pipe in big clouds of smoke.
Email me highgrooveauto30@gmail.com
Mine still does that after replacing timing chains guides and tensioners, new oil and filter The rattle is the cam phasers, particularly the inlets
I replaced water pump 3rd gen Prius Now ac not blowing cold I already check fuses Everything is fine
Great vid!
Baddasss brother! Thank you!!
Hey where do you get your o-ring for your injectors when you put new ones on injector
Throttle body had the same problem. Also check your spark plugs.
Is that motor the same as the chev utility
Good job 👍
Thanks 👍
Why in the world would VW make such a flimsy design?
Are you able to get the rocker covers off without having to take almost everything apart in the engine bay? Also, is it a reasonable expectation to change the lifters with the engine still in the truck? Thanks
Good video. The only thing I would have done different was maybe get a can of engine gunk and a pressure washer and cleaned the engine before I took it apart. Lots of dirt on that engine you don't want falling down inside. I have a 3.8 supercharged in my Impala that I will have to do gaskets on soon.
Oh, thanks for the video
This repair SUCKS. Doing it now. Good luck!
Cost…$3800.00
Clean the fins of the radiator and A/C condenser and take off that stupid cover on top of the engine and watch the temp go down. Why they took out the front grill I will never understand. Not enough air goes into the front of the engine to cool it down. The air coming in from under the front makes it a giant vacuum cleaner, sucking up tons of stuff while driving. I am planning to remove the cowling in front of the radiator and add some more window screen to keep the junk out of the radiator. The 3.5 engines are garbage, hastily made and not thought out before throwing them in as a replacement for the 3.8. The 3.8 is still one of the best engines built by GM.
Thanks!
THE WIFE AND KIDS AND I THANK YOU FOR THE SUPPORT!
I've been finding a bit of oil in my coolant lately on my 2011 forester. I know its not the same engine but would this possibly happen too? just looking for anything thats not a headgasket hehehe
my lower power steering pump bolt is rounded off and stuck. ANY ideas?
Hey thanks a million times over !!! You really saved me from junking my ride.that Interference info saved my motor.. ❤❤❤
My 5.0 fx4 scab got a bit too warm a few days ago. I opened the hood and began inspecting the hoses. Right away I noticed the upper hose was collapsed. Thanks for posting the fix!
Not only is this alternator buried under the cowl up against the firewall, what are the odds of replacing one only to have a bad bearing in the new replacement. Ask me how I know...
Your video was one of the better videos that I've watched with good information good job
Great advice 🤝
How long will it take me to do my valve covers I got a Chevy tracker 4x4 2.5 v6
Having my passenger side done tomorrow at the shop, I don’t have much tools, no abs wires on that bearing? My backyard mechanics that I usually hire to do mechanic work don’t seem to want to do the bearing assembly lol that’s fine. It sure wore down my brand new winter tires :/ I did hear a noise to, I should have known it was the bearing, I thought it was just my brand new tires lol.
My 2015 crv has the occasional rattle at start up do you think i can replace the tensioner without taking everything apart ,just the cover plate it seems veri close or a bit under the crank pulley thanks .
Angela
I was going to get rid of my 360 and just lose the games but is Gide was Great
What was it cuz mine is doing it to
Air hammer got my axles through the bearing on my van. The axles are a PITA. And I'm in the same boat, no lift.. haha
i do free oil changes for my neighbors makes em happy and doesnt give em a reason to complain love thy neighbor
I quite doing anything for free. learned my lesson on that real quick.
Привет с другой стороны земли )
Hello! thanks for watching!
Help me matt
I have a a 08 saturn vue crank no start
Email me highgrooveauto30@gmail.com
OMG. Just picked up my 2000 Oldsmobile intrique , 90 000 km, from the repair shop: Had some tiny leaks. Miniscule leaks, but my husband is so fussy.) The pressure test suggested new water pump. After installation it overheated. Never overheated before. Could not bleed it fully. Installed new thermostat. Still overheats. Suggesting head gasket. But can not get one. Was told "car is too old!"?