Video

It happened to my 1999 Honda civic just now. Did it work?

Do you have to pull the engine to replace the rear head gasket?

Do they still test them in 2024??? Old school cars.

How did you get the compressor out from the top?

DOES IT HAVE TO BE INSTALLED UNLOCKED?

I've wondered if the injectors can cause it my problem started from the rear one which normally rust causes the fail. After I replace them the codes are now two of them 332 and 327. The 327 wasnt present until repair. Although 332 was always present.

Change battery if it starts then dies if all fuses relays good.

2008 Honda accord recent incident: I figured out that I would I guess locked my door but car thinks I’m not in car. Red security light would start flashing and alarm keep going off!! Start car alarm go off. Turn it off still alarm. Open door alarm. Solution: get out of car put key in door and simply turn left and right. I read that somewhere and tried it. If worked. Called Honda they say faulty wiring due to mice and $800 blah blah.

I don't comment on yt videos, but the Die Antwoord in the background... 🤟

¿Dónde puedo comprar el dado pentagonal para los tornillos de ese Actuador?

¿Dónde puedo comprar el dado pentagonal para los tornillos de ese Actuador?

Yeah i think i got a leak cause when i use high milage last time my car was smoking can qnybody give me sum advice on what it could b?

So nothing bad would happen if I clean it off😮

Will this work on a 2003 Honda Accord ex sedan 4 door?

Solution: Switch to Premium gas and it will fix your problem.

i see its an old video. but was wondering .........someone said after you set dead perfect timing top & bottom ........ even tho its perfect set, once your release tension, that tensioner will cause it to be out of time 1 tooth. ..Opinions ????

May 26 2024 , hello , I have 2006 gmc 1500 Savana 5.3 L v8 . I have replied the knock sensor 2 x now . After driving 2000 miles the code po332 Knox/combustion vibration sensor 2 circuit low bank 2 . Why ? I have cleaned the pins that connects to ECM and 2 wires come from harness that connects to Knock sensor connector . ( if this code come up I well just replace new pins and wires and not use the old wire in the harness) I checked the continuity it is closed and good . Question is ; how do I check the voltage of ECM ? Also do I need to check if the new knock sensor is readin the knock from the motor three the wire to ECM . If o do how do I do this using a , Etekcity ( brand ) multimeter ? What is the right voltage ? When it listen for the knocks , what is it supposed to read ?

Didnt like ur over talking nor music and i am not going to take out the cam thats chilling from the factory to do this. There has to be another way.

So worthless fucking video just to say "get a new one" f you dude learm how to fuxking show solutions

I have a 2003 Town & Country Lxi at 134,563 miles that is doing something similar but no check engine light. Got it from an auction, and I don't think a lot of maintenance was done on it. When I start it up at the beginning of the day, it starts fine, but as soon as I put it into drive or even give it gas while in park, it stalls or chokes out. Does that once or twice every first start up now for a couple of weeks. Seems to drive fine, except it will sputter a bit when stopping fast or speeding up. Also, it will idle between 1.5-2 RPM at least half of the time. It might potentially have a faulty gas gauge as well. Some recent repairs I've had done on it to rule out some other potential issues are these: new battery, spark plugs, serpentine belt, cabin air filter, and has had a fuel system service clean. It could be dirty sensors or other things from sitting to be sold at an auction. I'm hoping it's not the fuel pump, trying to narrow down what it could be. Any thoughts? Much appreciated!!

Thank you bro it worked like a charm!!!

Can you clean with Awesome and hot water while the alternator is still on the car?

Touching the tail light connector pieces is asking to break the brittle wires in my expiriance

Thank you for your valuable information. looks like Toyota updated the gear with new design looks a little different. i wish if i can send picture for it.

Did changing the alternator fix it ?

These cars have electronic throttle body’s not drive by wire I move it myself all the time. If you do a thorough cleaning on the throttle body tho. Disconnect the battery for 15 minutes & reconnect and turn your key 5 times and start it on the 5th turn and let it sit for 5 minutes and it will relearn its throttle position.

Dawn power shot thank me later

Thank you

I’m going to try this thanks a lot buddy

Did this end up being a succesful repair. I have one in the shop .

goodbye bearing greese

I am having the same problem with my 2015 Honda Accord and I have the alarm code 66-13 and 66-11, any help what I have to check??

What could be the problem if you fix it locked

So what happens if you fix it locked is an problem

We changed the fuel pump wish was Cain of complicated and try the new one and we got nothing we couldn’t hear any noise from the pump so we take it off again to return it.until I watch your video wooow it did exactly what you did so we put the new wire and start right away thank you so much 👊🏻

Why should you unlock the timing gear before you replace it? Do you have to lock it again after the timing chain is installed? Please explain.

Thank you sooo much!!

Is the 2007 2.0 transmission different from a 2.5 transmission of same year?

Good info. Thanks!

Did you ever get it fixed

I did mine as you suggested. Worked out great. Thank You!

How about the valve. Can you test it?

tucson 2009

I’m glad everyone car is getting fixed with these hacks but I tried everything did exactly what the video said my alarm literally still was flashing and I obviously broke something else doing this because now when I sit n the car my drivers door won’t open from the inside so I still have my alarm problem and now I can’t open my drivers door lol

I did this and now I can’t open my drivers door from the inside lmfao greattttttt

Thank you so much… Replace my knock sensors on a 2000 Silverado 3.5…. Kept getting knocked sensor code… I took the wiring harness off of the ECM, cleaned all the connections, erased all the codes, the code has not come back, but it’s only been one day, so we’ll see in about a month….. again thank you for sharing your video

Why the gasket don’t go all the way around

Hi Jonathan My alarm is going crazy on 2005 honda accord diesel estate. I took out the 2 relays today and the alarm is still going off continuously. Any suggestions please Best regards

Love the music and thanks for the video

Cutting a 18mm wrench in half makes it way easier