Video

You're welcome. There will be more like this over time. There are a couple of others there that may be of interest to you.

Audrey is a 2022 model Lifestyle Camper Trailers - ICONN E2. If you would like to know more, reach out to us on FB at Audrey the ICONN Adventures.

Not recommended. A lot have a form of mange.

There are some steepish sections. Just travel careful & you should be fine. We saw a van about that size come in on the Saturday. We worth the drive in.

Thanks.

If a kiwi fruit was the size of a suitcase

Entire place is sooooo green. Being in Kangaroo Valley, I expect it always is.

🚘

The cabling runs inside the kitchen side drawbar rail. Pops up into the floor frame & then out again. Then up into the section behind the cutlery tray. Now up the back wall to the elec panel all the way to the 50 Amp breaker. Now back down the back wall, along behind the cutlery tray, into a tunnel behind the wheel well & into the battery box. You can use the cabling through the drawbar as a draw cable. Then drill holes into the floor of the battery box. You need a 50 Amp breaker as protection in your new cabling. The factory cabling is big enough 6B&S to run most any setup you would have. Just pull it back down from the elec panel etc to get it underneath. Will save you a bundle of $$$. Reach out if you need any more guidance.

@@AudreytheICONNAdventures So if I cut it behind the cutlery tray and redirect back from there to battery box it will then be direct to drawbar ? I'd already deleted the circuit breaker and just joined the positive cable behind there. Where did the anderson negative go, same route or to battery box ? Thanks for the reply.

From memory negative goes via the negative link behind the elec panel, same route. I think if you cut behind the cutlery tray & pull the negative & positive back through you should be ok. I did all this late last year, so hoping I am remembering correctly. I spent about a day sorting out what each of the cables behind the elec panel & in the battery box did. If you cut as close to the back wall as possible, there should be enough length to come back into the battery box via the same route all the other cabling runs. If you disconnect from in the elec panel, you can pull them down & definitely have enough. You can use 1 of the other cables to draw through.

Last year the awning wanted to be on the drivers side, so always 2 ropes each end now to keep it where it belongs. Poles have to stay up somehow, so ropes required. They help stop the walls flapping in the wind. I was testing a different setup yet again in preparation for an outback trip where I needed to setup a swag near the drawbar.

Gidday. That particular area was due to not enough silastic around the fill hose where it passes through the floor. Other areas appear to be from the seam sealing not quite taking. Not sure if it was incorrectly applied or the product didn't like sticking to the plastic floor. Audrey is a July 22 delivered ICONN E2. My understanding is the new ICONN E2 Next Gen has had more attention applied to underneath. If you have any questions, feel free to reach out. Get on facebook.com/groups/officiallifestylecampers & messenger me - DTOY Racing.