Video

Thank you very much. Very helpful instructions. I saved a lot of money thanks to her. It's great that you provide the screw tightening torques and all the details.

Thanks a lot! I helped my neighbour to enter his home.

Thanks! I was trying to figure out how to remove the tow bar being stabbed by the mosquitos every 5 second. I wouldnt make it withot the video.

How many miles you change it ? Didn’t look that bad …..it was making noise ? Usually they last high miles ……

Stupid video

Pueden decir cuál es la numeración de la cvt

Yeah, and bear in mind that this is a new one! So if it sits there for a few years...,more elbow grease, hammering and some WD40 is needed!

It is the best crimper? im looking for the best crimper. Greetings from argentina

Také jsem dělal videa o výměně na alku. Jen pár poznámek. Do nového olejového filtru nelijte olej. Olej se do filtru může lít pokud je našroubovaný svisle dolů a pak olej nevyteče. Olej určitě neměňte za SAE 30 a dál používejte alko 10w-40 (specifikací splňuje požadavky výrobce motoru). SAE 30 je jen na letní provoz a nižší teploty pak nejsou s tímto olejem dobré pro motor. Například na podzim při sbírání listí už jsou nižší teploty. Ať vám stroj dobře slouží.

God bless you, Ladislav, your video just saved me a fortune, bought 2 capacitors for 1 euro, replaced them and boom!, the error has dissapeared and my boiler is now working normally, no F. 61 error anymore for 1 week already! Thank you for your effort of making this video, and thanks also to other commentators for valuable inputs. Checked later the removed capacitors, they were way out of tolerances, one was dead completely.

Muy bueno 👏👏👏👏👏

Really good info. Thank you!

Muito bom seu video! Parabens! Faz mais videos!

Also that USB charger cord? Ultimately a meter? You have plugged into 12v dash access…where is the other end of the wire going?I currently have a dash cam plugged into that right now though.

Thank you very much for this video that was very helpful. I have a 2023 Highlander hybrid that I inadvertently left on without my key and went in somewhere for about an hour and a half 90 minutes and when I came out it was totally dead check engine light I could not start it however waiting like 20 minutes. It did finally start for me but I’m worried about the battery now and wonder if I should have one of these in stock on a tender possibly just so that I’m Ready? These little 12v batteries I’m assuming are more prone to expiring sooner then there larger counterparts? AND especially if fully discharged as described earlier wondering if damage could have occurred and thus shortened its future life? Your thoughts/knowledge would be appreciated. Thanks in advance.

Great video mate 😊

Има и по напред в ляво още един филтър за 17мм инструмент!

All boiler engineers should watch this!! I had an F.61 fault on my Vaillant Eco Tec Plus, and the engineer simply replaced the whole PCB without even considering the possibility of testing the capacitors. Who trains these guys?

Thanks brother save my life 😂❤

🎉🎉🎉🎉🎉

I own a c650 all time used with jcosta, and is not necessary to change only the chain, i have 37k km and it works well, for me is better to change all the kit trasmission on 40k and that s it

Is someone about to cum?

Great video..

Dík, du se snad dostat domu

Just out of curiosity, why did the chain need to be replaced?

Lado ten pekac na ten olej je top

I changed both capacitors on my vaillant 837...f61 and f62 errors...after changing the boiler was back on running...saved 200£ on a new pcb

Our strongest strings tore apart, could you recomend a strong type of strings

what tablet is that? looks massive!

Note to viewers. When you change your caps, after installation of the PCB press the ignition button on your boiler to reset the F.61/62 errror otherwise the error will still remain. My caps had high ESR also and validated it with a ESR meter, unfortunately you can't test ESR with a multimeter and it's not the same as resistance as the dude in this video keeps saying. The capacitors only cost a few pounds if not less and you will need to unsolder the old ones off and replace them with the new ones, making sure you note the orientation of the negative and positive terminals, so you can correctly solder the new ones in place.

Thank You dude! 🖤 It was very helpful and it worked. I saved a lot of money for a locksmith. You rock!

What is the 8 mm tool you used on the bottom drain called? I need one. Never minf I got it off with a large 8mm allen wrench.

hey mate. thanks for the video. it helped me to open my house. I failed on the first window with a cloth and entirely closed the door, but on the second I used a pipe instead of a cloth which much easier fits on the handle, and did not even use the 3rd wire to close the door. the 2 wires on the top and the bottom of the pipe were enough. much appreciated! :) take care

Man, thank u forever. Went to walk my dog and forgot the key. Luckily it's a base floor, and I have some tools and ropes on the balcony, but it wasn't easy. Not a thin rope, so took a while. I improvised with ducktape and the rope...and finally got in. Thank you again very much, saved me. Just had enough battery on my phone to check your video, huuuh

Thaaaanks I just enter in my home, i forgot my 🔑 at gym

Thanks, nice bunny by the way 😂 🐇

Merci pour la video , certaines similitude avec le t max yamaha

Do knipex has a passthrough crimper?

The problem with my towbar is that the indicator is already on green/red. And there is no change when I click it in.

Que medida tiene la corre?

Where would i buy the capicitors from?

This just saved my day! Thank you.

I can confirm after two winter month, that the fault disappear after the caps replacement.

Somun'lar kac mm ?

Just what I needed! Thanks!

Youre the best. I was wondering if the knipex rj45 crimper would be worth it, but seems like it is.

amazing

THANKS

This scooter is being discontinued 8 think

Top job! Only 500ml oil?