Video

Wala po Sir. Nothing special. Deretso sya via wifi…

Hi! Wala kase ako sa Pinas as of the moment. Però sa Lazada, search ka ng misting pump na 12V, around 90psi. More or less yan ang spec ng gamit ko. 3A lang yun. Very inexpensive. Halos 300+ lang pagkakaalala ko.

An old treadmill motor.

It still does, after over a year.

Mine is completely operational. Are you on iOS?

Same here . Made the scene and set up perimeters . It does nothing . It alarms but doesn’t switch on my smart plug

Hi! Thanks for watching. My sensors are submerged all the time, yes. I’ve had errors twice with my pH since I installed them last August last year, and during the last failure I thought I’d have to replace the sensor because of the offset (I was getting around 11 for my pH when it was having around 7.5!) anyway I just let it plugged, seemingly corrected itself. I rarely do manual measurement since I’m away from home since January this year. For TDS, hopefully it’s still correct. My sister who takes care of the farm while I’m away doesn’t know much, so what I get from measurements are my only trigger to give her instructions on adjustments. To answer your question, there might be errors already. I’d come to know when I come back within couple of months more. :) will keep everyone posted with my update post when I get back. Enjoy!

Oh! By submerged, we both mean only the tip right? :) the cable part cannot be soaked with water I guess.

@@musikerongbundukero Great, do you have any recommendations on the brand of EC sensors, perhaps yours of the highest quality. Would I like the model and make please?

Probably. Doesn’t your wifi AC have a thermostat of its own? If it gets temp reading elsewhere, this controller could give what it needs.

@@musikerongbundukero it does but I'd I put it in a other room it can tell it to cut on and off , the issue with on board thermostat they only are good for that one room

That’s how exactly this one is configured. :)

Nothing in particular. I use a cheap aquarium pump, 32W. Sa setting, nagbabase sya sa reading ng PPM. App ang nagra-run. Sa cloud (or sa internet) sya kumukuha ng command via app.

I haven’t found one like this yet, in case I come across I’ll let you know. :)

Please send me message at the FB link I mentioned below. I’m currently away from home. So away. Haha.. I’m more than willing to help fellow enthusiasts like you bro. Good luck!

They have really flexible output base on your needs. They can be time based, and in my case I used both reading-based using ph and tds/ec values and time-based that I only do the dosing at night. :)

Hi. Thanks. Search for @gaboficetubeHaven (Gab’s Haven)

Nothing in particular. I use a cheap aquarium pump, 32W.

I don’t exactly remember but I purchase usual low wattage aquarium submersible motors.

Basically it’s relative, but thanks. Got my system ROR for 9 months, so I’m sure it’s not so bad than what you might have thought.

Thru lazada po. :) search for RC YGO store.

czcams.com/video/3hdRJ4HHp-4/video.html

Hi. Give me yours, I’ll message you. :)

@@musikerongbundukero neevejose

Salamat Sir. Marami pa troubleshooting involve… hehe.

@@musikerongbundukero is this a passion project sir? Im looking into starting a hydroponics/aquaponics hobby den. 🙂 As of now im into planted aquariums, feels like more or less may similarity kasi sila.

@@nelsondolot full of passion sir. Hehehe.. Basically most supplies I use are from aquarium shops. :). Honestly, this tiny farm is like a research and. development I needed for a commercial grade farm I plan to build in the future. Salamat naman somehow dahil income generating na sya... :) Hope you find this useful. If there's anything I can do to help just let me know.

@@musikerongbundukero sige sir thanks. pag may questions po ako message ko kayo. With regards to automation if makakatulong ako you can send me a message den. 🙂

Thru the app. :)

I did the video, and I had to always take a look everytime I need to do it too. LOL hope it helped you. :)

Wilcon po.

Wilcon po.

Hahaha!!! This made my day. :) thanks for watching.. anyway the same song is uploaded here. How it’s better for you :)

Ma’am Hindi po. I remove the back seat one time na nagkarga ako ref... :)

I invented it. LOL Thanks for watching bro..

Ivan Ferrer May plastic cover po yan Pero fully transparent. Ang filter ko ng sunlight is the net above it (hindi yata nakikita dyan sa video)

Carmie Ramirez hole saw is the tool. It’s like a circular (cylindrical, like a drinking glass) we attach to a hand drill.

EZY3D LAB sa Wilcon po.

@@musikerongbundukero Thank you po!