- 14
- 2 183
Alex Hedrick
Registrace 22. 10. 2009
hondda hobbit with lots of custom stuff
honda hobbit, custom subframe, piaggio crank, stage6 piaggio driveline, custom jackshaft to chain drive, stage6 r/t 70cc cylinder, crankpipes tuned pipe, stage6 24mm d slide carb, stage6 vforce read block, custom intake manifold, 12t front 74t rear, hpi inner rotor with 2 stage curve cdi.
lots of port matching/flowing the cases, touched up the porting on the cylinder, .03" squish gap, standard timing set pet hpi manual.
so far it rev'd out just over 15k speed unknown yet. but its stupid fast so far..
lots of port matching/flowing the cases, touched up the porting on the cylinder, .03" squish gap, standard timing set pet hpi manual.
so far it rev'd out just over 15k speed unknown yet. but its stupid fast so far..
zhlédnutí: 159
Video
Puchwa with porting and hpi mini rotor
zhlédnutí 224Před 5 lety
Puchwa with porting and hpi mini rotor
Jawnum 70cc k-star kit..
zhlédnutí 100Před 5 lety
After decking the cylinder down .7mm and opening the exhaust some, cut the piston skirt some on the intake side..
How does it perform?
Dude sick!!
Did you move the tank up? I’d like to see the mounts for the radiator
That's tricked out, looks absolutely gorgeous. Are you planning on doing the big bore kit along with the water cooling? Also where did you get your parts? Treatland?