- 22
- 39 296
Martin Warren
Registrace 3. 06. 2014
Marine Electronics Installation and Sales. Marine Electronics instruction
Landu Pontoon Sea Trial
This is the sea trial performed after the complete rebuild, showing the engine running and all of the electronics operation.
zhlédnutí: 24
Video
Landau Pontoon Walk Through
zhlédnutí 71Před dnem
This is the walk through video after a complete rebuild.
Garmin Transducer Disable, turning off CHIRP transducer on Garmin GPSMAP units
zhlédnutí 249Před 2 měsíci
This shows how to disable the CHIRP transducers on Garmin GPSMAP MFD units.
Raymarine ST60 and ST6002 Autopilot Service call
zhlédnutí 1,9KPřed 3 měsíci
The customer called with a non-working Autopilot and the Wind Instrument was not powering up. I did a system and network check and found two bad Sea Talk cables and connections and a bent seatalk connection tab on the ST60 instrument. Straightened tab and replaced cables resulting in full functioning units.
Sionyx Nightwave with a Simrad Evo unit
zhlédnutí 1,3KPřed 7 měsíci
This a SIONYX Nightwave camera connected to a Simrad NSS EVO unit and how to access the camera on the screen
Garmin Autopilot Sea Trial Commissioning
zhlédnutí 692Před 10 měsíci
This isn't the actual commissioning, but it's how to get to the menu/screen to perform the commissioning.
SeaRay340AJ Completed Raymarine Installation
zhlédnutí 44Před 11 měsíci
Overview of completed Raymarine Electronics installation
Garmin Autopilot Set up and Commissioning - How To
zhlédnutí 6KPřed rokem
Garmin Autopilot Set up and Commissioning - How To
Garmin GXM54 Audio operation with the Fusion stereo and Garmin GPSMAP and Echomap units
zhlédnutí 1,6KPřed rokem
Garmin GXM54 Audio operation with the Fusion stereo and Garmin GPSMAP and Echomap units
Garmin GXM54 weather module operation with GPSMAP screens
zhlédnutí 755Před rokem
This video goes over how to see and use the different weather layers of the Garmin GXM54 Weather Module with the GPSMAP series units.
Using the Simrad OP50 controller on multiple screens, NSO and NSS models
zhlédnutí 468Před rokem
Using the Simrad OP50 controller on multiple screens, NSO and NSS models
Adjusting Sonar Frequencies on Simrad NSS evo3
zhlédnutí 2,7KPřed rokem
Adjusting Sonar Frequencies on Simrad NSS evo3
Making Combo screens on Simrad NSS Evo2, Evo3, Evo3S
zhlédnutí 678Před rokem
Creating combo screens on the Simrad NSS Evo MFD units.
Using the Garmin GXM54 Weather Module as the audio tuner.
zhlédnutí 160Před rokem
Using the Garmin GXM54 Weather Module as the audio tuner.
Garmin Reactor Autopilot Sea Trial Commissioning
zhlédnutí 337Před 2 lety
Garmin Reactor Autopilot Sea Trial Commissioning
Using the Navionics Shaded Relief with a Simrad NSS Evo 2/3/3s or GO series MFD GPS
zhlédnutí 7KPřed 2 lety
Using the Navionics Shaded Relief with a Simrad NSS Evo 2/3/3s or GO series MFD GPS
Dr Warren does an amazing job w marine electronics. He has outfitted my vintage 290 Outrage w Lowrance GPS and depth finder, SITEX radar and now Sionyx. After my complex installation he has only had to return to the vessel once to adjust. After 55 years of hard offshore boating I like the simplicity of the Lowrance line. Going all the way back to flash/ spark depth finders they always work. Simrad is great for my techie friends but I manage to get mixed up as it does so many things. I will try this installation and unit this weekend.
So would it be okay to mount on top of a center console helm, even though there's a hardtop? I'm going to have the Fantom 24x on the hardtop on a 5" Seaview and want to avoid interference
As long as your hard top isn't metal/aluminum, it should be fine. You can connect it before you mount it and hold it where you plan on mounting it and see what the antenna strength will be. The GPS unit it's connected to will show you it strength in the upper corner. I have mounted a lot of them under hard tops without issues. Just a note: you might need to call SiriusXM and activate it before you can check the antenna strength.
hello having trouble with commising my auto pilot , i have a simrad , lowrance system . when I run my comminisg test my motor locks on starboard and will not come back to centre. Any help or suggestions are welcome
This video really helped me with mine. czcams.com/video/3UJE0gLT4oE/video.html
How do you engage the troll feature?
Can you do all of this on the GO model?
Can you adjust the autopilot heading with the physical knob?