Desert Rat Garage
Desert Rat Garage
  • 14
  • 4 187

Video

Wood cart (made from pallets)
zhlédnutí 90Před 8 měsíci
Wood cart (made from pallets)
Looking into the problem with the CT90
zhlédnutí 52Před 10 měsíci
Looking into the problem with the CT90
CT90 pt:3 I hate wiring. (Only 2 wires)
zhlédnutí 1KPřed 11 měsíci
CT90 pt:3 I hate wiring. (Only 2 wires)
Trying something out. Also I made a shade canopy out of some pallet wood.
zhlédnutí 22Před rokem
Trying something out. Also I made a shade canopy out of some pallet wood.
CT90 pt:2 (engine rebuild)
zhlédnutí 147Před rokem
CT90 pt:2 (engine rebuild)
Fixing up my CT90
zhlédnutí 77Před rokem
Fixing up my CT90

Komentáře

  • @ryanmundell3504
    @ryanmundell3504 Před 2 měsíci

    Grate vid do you have any recommendations for a easy install

    • @desertratgarage9480
      @desertratgarage9480 Před 2 měsíci

      I didn’t really install this it came stock like this from the dealership.

    • @desertratgarage9480
      @desertratgarage9480 Před 2 měsíci

      If your trying to install some tweeters then I would think you’ll need to run a few wires from your door speakers up the A pillars and then in the roof but need to take the head board off in order to install it.

  • @user-pg6jl7jw7s
    @user-pg6jl7jw7s Před 3 měsíci

    If your battery keeps going dead on you, it's because you don't have the rectifier hooked up.

    • @desertratgarage9480
      @desertratgarage9480 Před 3 měsíci

      Yes and I know that but I’ve also mentioned in the video in the same clip where I said “im not going to be running the rectifier because my stator is bad and doesn’t produce any electricity or charge to the battery”. It’s closer to the end of the after I’ve shown the bike running. Also thank for commenting your are the 2nd who has commented overall and really really do appreciate it.

  • @prestonholland2280
    @prestonholland2280 Před 4 měsíci

    spitting oil out the exaust was caused by your honeing job

    • @desertratgarage9480
      @desertratgarage9480 Před 4 měsíci

      Thank you for being the first to comment I appreciate it but if you also watch the other video I made about looking further into the engine I have mentioned before many times that theirs really bad pitting all over the cylinder walls from it rusting and sitting and their for the oil was bypassing through those gaps. I didn’t hone it that deep or that wide open. Also the pallets were free from picking up elsewhere, I wasn’t meaning that it’ll free up space.

  • @prestonholland2280
    @prestonholland2280 Před 4 měsíci

    the pallets wernt free you lost all your space