- 13
- 11 473
Vlastimil Poruba
Registrace 26. 10. 2020
damage of the tyres after air bubles explosion
damage of the tyres after air bubles explosion
zhlédnutí: 48
Video
laotie ti30 - no working front motor, rear motor slow working, controller faulty?
zhlédnutí 5KPřed rokem
laotie ti30 - no working front motor, rear motor slow working, controller faulty?
Laotie ti30 - no working second slot for charging
zhlédnutí 252Před rokem
Laotie ti30 - no working second slot for charging
laotie ti30 - not correct working rear motor (probably nok hall sensor from production)
zhlédnutí 302Před rokem
laotie ti30 - not correct working rear motor (probably nok hall sensor from production)
Laotie ti30 - poor quality deliwered by bangood (1st motor not working, 2nd motor low working)
zhlédnutí 423Před rokem
Laotie ti30 - poor quality deliwered by bangood (1st motor not working, 2nd motor low working)
Hello i got the same problem but i ordered the new front motor and the controler but the reapir shop told me its not the good one.Can someone please help me and show me what motor and controler i should buy.I can talk trough instagram too i just need help repairing it.):
Do not connect them with any wire
The front motor wires are interchangeable
I had this problem with my scooter too, I fixed it, if not with your scooter, let me know if your scooter is working too.
I also have this problem the front tire sometimes works and sometimes doesn't
batterie
were you able to smell the controller for anything burn or front motor??? mines both is not working and i see brownish stuff in both my controller and my rear motor the phase wires melted a bit and also smelling burn smell from both my controllers.
Same
any idea on why my back motor of my laotie ti30 makes a loud rumble and rattle noise when i first take off. only occurs when scooter is on the ground.
I have this same issue and can't seem to find a solution
@@mstrpth287hello did you find the solution?
@darius_football893 not yet. People say the hall sensor but I don't think so, I don't believe it's bearing related. My guess is the controller but I have nothing to back that up with.
@@mstrpth287 Do you know where i can find a front controler and a front motor cuz i dont know what type of controler it needs but i know the motor.If you know a good webstie (globally) where i can find the right controler it would help (sorry for my bad english i am from romania)
@@darius_football893 I don't, sorry. I haven't looked into it all that much as the scooter still runs. I think I'm going to switch the front controller with the rear and see if that makes a difference. If so, then I know it's the controller.
Ahoj,mám Boyuedu,,ta samá závada,nakonec jsem našel zlomený kablik ve svazku co vede k přednímu kolu,byl zlomený pod sk páskou
how much you paid? did you pay for shipping insurance??? return for replacement??
Hey did you find solution?
Yes, new front motor and new front controler (controler burn motor...)
When I checked the motor with the front controller, it still works. I think the problem is with the controller or the red button. @@vlastimilporuba7209
If by disconnecting the HAL terminal block and it runs smoothly that would say there is one or more HAL sensors that are not working.
Zdravím.co znamená ten cerveny čtverec na displeji? Nefunguje mi plyn. Jinak vse sviti.. netoci se zadny motor
0:57 why mine is 25km
Mám stejný problém, přední kolo se netočí a zadní jen pomalu a také nereaguje na červený a žlutý přepínač. Zkusil jsem rozdělat controller nefunkčního motoru. Hned po odšroubování bočního krytu bylo vidět opálené místo mezi deskou a hliníkovým obalem. Větší vrstva cínu na plusové cestě se pravděpodobně otřesy při jízdě dotkla obalu a vyskratovala controller.
Ahoj, tak to mame stejne. Mel jsem odpapeny predni kontroller a po vymene za novy je vse ok👍🙂
@@vlastimilporuba7209 Také jsem hned objednal nový, za týden byl z Banggoodu doma a zase jezdím.😀
Does the charger work now?
Was it the controllers?
Hello i got the same problem. If you made it can you Tell me What is the problem?
i got the same problem too. but the strange thing is that when i spin the front wheel by hand ,it starts working .
@@veikko-tc1gi ill try it
@@veikko-tc1gi i have the same problem did u fix it
@@peterryan9951 not yet. i think ,the best way is to find electrician ,who has tools to measure electric current coming from battery to the motor and find out ,why motor does not work instantly.
@@veikko-tc1gi im just after taking my front wheel apart on green wire hall sensor getting no currant i followed it back to a clip from there it is small blue wire to controller still no currant so i think il do more testing to see why .
My battery indicator always shows 100
hall problem
Have you fixed the problem or bought a new motor?
I still solve it with supplier. I have electric scooter cca 2 weeks... Im not happy with this situation. Front motor off (not working). Rear motor low working...
The motor wires is not connected properly. Try connecting the wires to the controller properly and test it. If that does not work change the whole motor
What problem ?