![SoundSpeakerRepair](/img/default-banner.jpg)
- 8
- 1 941 808
SoundSpeakerRepair
Registrace 16. 01. 2009
This is the home of SoundSpeakerRepair.com's speaker repair / reconing and diaphragm instructional video.
Soldering 101
This video shows how to solder speaker lead wires to the terminals. This video also shows how to solder two wires together and how to solder a wire to a slip on terminal.
zhlédnutí: 81 028
Video
JBL 2404, 2405, 077 and 075, 2402 Installation Video
zhlédnutí 56KPřed 15 lety
This video will show you how to install this JBL 2404 diaphragm into the JBL 2404, 2404H, 2405, 2405H and 077 driver. This video will also show you how to install the JBL 2404 diaphragm into the 2402 and 075 drivers with a very simple trick saving you loads of money.
Testing a speaker with a 9 volt battery
zhlédnutí 248KPřed 15 lety
This video will show you how to test a speaker with a 9 volt battery. This test will show you if the speaker is functioning and if the polarity is correct.
How to recone and repair a speaker or woofer with a Pro Parts recone kit
zhlédnutí 1,2MPřed 15 lety
Video instructions for installing Pro Parts preassembled recone kits from Sound Speaker Repair. Pro Parts kits make speaker reconing simple. Pro Parts kits are preassembled using jigs specially designed for each speaker, then glued to insure that the voice coil, spider and cone are perfectly centered every time. Using a Pro Parts recone kit will restore your speaker or woofer back to new condit...
How To Test A Speaker or Tweeter Voice Coil
zhlédnutí 244KPřed 15 lety
This video will show you how to test and measurer the ohm value of a speaker or tweeter voice coil with an ohm meter.
Fostex-Foster N30--Cerwin Vega H25
zhlédnutí 12KPřed 15 lety
How to video. Repair your Fostex / Foster N30, Cerwin Vega H25 and all similar drivers and horns. Very quick and easy to install. Just a few bolts, a new replacement diaphragm and your tweeter will back up and running.
EV-DH3-2010
zhlédnutí 32KPřed 15 lety
This video will show you how to install and replace a new Pro Parts diaphragm in the Electro Voice (EV) DH2, 2010, DH2010, DH2010A ect... driver / horn / tweeter. Very easy, quick and inexpensive.
JBL 2412, 2412H, 2412H-1 Diaphragm Installation Video
zhlédnutí 112KPřed 15 lety
This video will show you how to repair your JBL 2412, 2412H and 2412H-1 driver and get your tweeter working again. The JBL 2412, 2412H and 2412H-1 replacement diaphragm can be found on our website www.SoundSpeakerRepair.com.
Can you tell me what it means if the speaker fails the test and shows no life. Is it possible to repair a speaker that does not respond to the battery test?
I found that using a heat gun loosens that glue and you can take the gaskets and cone and spider off without damaging them. It takes some time and patience though.
Cheers for the great examples, explanation and camera work
How much would it cost to to overhaul a Lanzar 10" viberant sub, it needs a new cone set. How much would that cost? For a reconing kit? Thanks
How do you get stuff out of the coil gap?
I just repaired my EV bass speaker with one of these kits. Great video, great paper instructions that came in the box. I could not be more pleased with the product. If you are on the fence about ordering one, It was very easy to follow the instructions. Year's ago I repaired a pair of advent speakers with another company's non-pre-assembled cone and coil with poor results. This (Sound Speaker Repair) is the way to go.
Very good explanation, presentation and demonstration! Good camera work, good examples, and good technique! Now I can rewire my car for an engine swap! Thank you.
Does this work for 10inch speakers from a peavey?
i feel like a dumb ass for throwing away a $300 dollar sub now... thank you
Very nice video. Would like to see one though were you are replacing the tinsel leads on a sub and have nothing to work with but the frayed ends of the old leads. This is common among subs such as the Kicker L7 where you can't get access to the voice coil to replace the entire lead.
Nice. This will help immensely as I attempt to replace the tinsel leads on a Kicker L7 12. Thanks for a great vid of excellent quality.
Really well made video. Proper tech tutorials are becoming less and less these days.
why cant all people do it as well as this guy thankyou thankyou thankyou
That's awesome! I was about to send mine out, but I think I'll try to fix 'em myself now!! THANKS FOR THE POST!!
great info!!!! thanks!!!!
amazing movie, I wish you were repairing my blown mesa 15"!
Thanks Man ,that was exacly what i was looking for. Thank You also for warnning with a graphite liquid possible damage.
five stars for shotglass
Excellent video, very concise.
5 Stars!!! Helped me recone the speakers my 3yr. old nephew punctured with a screwdriver.
***** Star Video!
good video
Thank you!
Thankyou very much!!
Very good video. 5 stars
thanx!
verry good video i was looking for something like this
wow thats amazing ur a lifesaver
that was a great video
thank you for that illustration, and technique. you're so creative.
coool
SWEET!! you should sell universal recone kits
Nice one Roger, keep em' coming, we'll be watching. -Caz