Video

i remember using allen keys from a set with ball end

no, we were able to find enough space for an allen key to turn the screws!Thanks

Arrow website says an increase in horsepower is expected when remapped!Thanks

Loosen all fastenings/screws/both pipe clamps that connect the slip on to the link pipe and slowly tighten alternately until you can be able to bring the gap close then finally tighten them all according to their proper torque value!that for me solved the problem!hope it works!

@@mylestv14🤛👍

so far, good,bike has only run 4k odo!thanks

@@mylestv14 that's awesome. Mine is being delivered next week 👍.

it is from Arrow Italy!thanks

we did not replace the gaskets/we assumed gasket stayed in its place when the manifold was removed!thanks

no,just use an allen key!Thanks

@@mylestv14 ok seems hard to get the upper bolts. But I will figure it out😃

when we unscrew it,the bolt was not that super tight!

On the top Bolt my allen key doesn’t fit well, would need 1 cm more space to get it in place.

Thanks Mario!

Glad it can be of help! Thanks n ride safe!

Thanks for watching!

Just ask your local Vespa dealer please!!Thanks

search for Bagoros Performance! Gracias

Mille grazie Gian! ciao

Ciao e w suzuki 💙💙💙​@@mylestv14

hehe magastos na libangan pre!

@@mylestv14 deserved mo yan tol at masipag kayo magasawa magtrabaho

@MrJunmirasol lahat naman tayo d2 kailangan magsipag! kayo nga ang masaganang pamumuhay pre☺️

naulan naman !!!

They are a single and if mine is anything to go by, the socket is loose and disconnects from the cable.

Thank you po Ninang😀

Thank you maybe we can try this with our classmates, thank you for watching my video!

there should be no gap, at first I thought the gap was too much but you have to loosen all the fastening first and the clamps be sure to insert also the original gasket!thanks

Hi thats PUIG for Suzuki short bar ends B505N

im not sure … maybe 4 kgs or more from stock(exhaust pipe, catalysator)!Thanks

Yes, higher rpm during idling! Throttle response is much improved esp in sport mode

Hello,paramore!no still stock air filter but asked the KTM handler to install evo mapping, much much louder!!! you can instantly feel more power on the lower end and mid range, have not tested top end power(top speed) because of strict speed limits here in Austria! Thank you for watching!

Did the Dealer charger you? Did you buy the bike from them? @@mylestv14

Yes, they charge fees for the mapping, I did not buy the bike from them(Ktm Vienna), I get the bike from Bregenz ! Thanks

Thanks!

bagorosperformance.com/

I‘m not sure 12, 13 or 14mm, its included in the bike‘s tool kit( sparkplug tool)!Thanks

hello! just visit their website bagoros performance! thanks

Austria!Thanks

yes, very easy! you can just remove the rivet and take the db killer out, then if you want to put it back you can use a short(10-20mm) M6 nut n bolts or put a fresh rivet back on! Thanks

@@mylestv14 Expecting mine next week. Hopefully it won't fry my turn signal!