![diamond_industries](/img/default-banner.jpg)
- 470
- 1 036 617
diamond_industries
Registrace 14. 07. 2008
Video
Grand River Regatta 2024 leeward mark
zhlédnutí 16Před 16 hodinami
Leeward mark rounding and windward leg with block failure.
Rock and roll half race team
zhlédnutí 6Před 19 hodinami
This is what we do while mama runs around the city.
How to get rid of a wasp nest!!
zhlédnutí 11Před dnem
My 7 year old gave me a great idea using a shop vac to force the sevin into the cracks of the house.
Grand River Regatta 2024 Double handed pt2
zhlédnutí 8Před 14 dny
Grand River Regatta 2024 Double handed pt2
Grand river regatta 2024 Double hand part 1
zhlédnutí 24Před 14 dny
Grand river regatta 2024 Double hand part 1
Grand River Regatta Double hand pre race 2024
zhlédnutí 17Před 14 dny
Grand River Regatta Double hand pre race 2024
Thistle sailing. Windward mark and downwind leg.
zhlédnutí 2,5KPřed měsícem
Thistle sailing. Windward mark and downwind leg.
Thistle sailboat racing at its finest!!!!
zhlédnutí 932Před měsícem
Thistle sailboat racing at its finest!!!!
Thistle project pt 13 Total Boat Top Side Paint
zhlédnutí 22Před měsícem
Thistle project pt 13 Total Boat Top Side Paint
Thistle project pt 11. Roughing in the bondo to fill old drains
zhlédnutí 11Před měsícem
Thistle project pt 11. Roughing in the bondo to fill old drains
Thistle project part 10, Filling in the drain holes
zhlédnutí 21Před měsícem
Thistle project part 10, Filling in the drain holes
Ashtabula Harbor Guest Boating Accommodations
zhlédnutí 268Před 3 měsíci
Ashtabula Harbor Guest Boating Accommodations
Thistle project pt8. Second coat of Totalboat topside paint.
zhlédnutí 39Před 3 měsíci
Thistle project pt8. Second coat of Totalboat topside paint.
Applying Totalboat wet edge Thistle project pt6
zhlédnutí 86Před 3 měsíci
Applying Totalboat wet edge Thistle project pt6
Sanding Totalboat topside primer in the Thistle pt5
zhlédnutí 41Před 3 měsíci
Sanding Totalboat topside primer in the Thistle pt5
Hi, nice video really. I got the same shed in same colour. May I ask how you built the foundation? Is it timber screwed on concrete slabs? Is there one more timber level crossing the lower one?
@@cankayasedat1 I built a deck like foundation with 2x4’s covered them with osb and set it on 3 6x6 timbers. Two in the outside and one down the center. The timbers were placed on cement blocks that I had placed in holes in the ground on packed down sand. I chose this to allow me to level it down the road and possibly move it if needed.
Btw these trucks can tow upwards of 15000 pounds not what ford said. They only said that because of legal reasons and highway/street laws.
Wait till winter amd ot condensates
Thank you so much 💙
Can you please share the instructions manual please?
The boat looks great! The key with Wet Edge is thin coats so it lays down nicely!
@@TotalBoat Thank you! The Wet Edge was really nice to work with, I will definitely be using it again on future projects.
Do you ever have problems with it trying to run hot when using the finish mower
@@MidGAOutdoor no problems yet. We have used the finish mower for about 30 years and have had minimal issues. The yard only takes about 1.5 hours to mow, everything gets warm but knock on wood we have not overheated yet.
Its usually Mahohany in a Thistle, not teak. You sure that's teak? Great boats, just refinished mine last year, she's all mahogany, hull and all
After looking at another of your videos, that's 100% mahogany
@@moosekiller2004 awesome! Thanks for watching and letting me know. I used the sickens cetol on it and it looks great.
Unfair! I bought my first sailboat, a dream since childhood! But my children are teenagers and have zero interest in sailing. My point, enjoy that you can sail, and that you can sail with them so young, and with so many years of fun ahead!
Any chance you could send me a pdf copy of the instructions to build this please?. I bought one from ebay but no instructions with it. Much appreciated if you can help out. Cheers
@@janetparker1507 mans.io/item/outsunny/845-031v01
Hello Did you have the instructions already?
What are they called????
@@susandavisrdh ez anchors or drywall anchors
Do you know if you can still buy those wall anchor hooks for this shed? It's been hard to find them anywhere. I see your shed has them hanging from the walls. And you also seem to have hooks for that weed whacker. Did those come with the shed?
If you search Rubbermaid shed wall anchors there are a variety of options. I believe the weed eater hook is shown in the results.
Great vid! Love mine so far. Does it stay somewhat warm inside or should I insulate it to store an ebike? Was thinking of using polyurethane foam.
It doesn’t get too hot in the summer thanks to the vents but it will be cold in the winter. Not too sure how to alleviate that, if you are concerned about your e-bike battery getting cold it may be a problem. Can the battery be removed and brought indoors?
On the bench, every artist leaves his mark Thanks for letting us share this journey
cool//////////
i just installed this myself, it seems really cheap to me. I bought self tapping screws and rubber roof washers for the roof panels.
I did the same thing. I got tired of trying to hold those little screws with my fat fingers.
@@chopper5245 what size did you buy?
@@user-wu1fp4xq5l I bought screws that were just a little bigger than the screws that came with it. I just took one of the screws with me and went by that.
Hello Do you still have instructions manual ?
@@patbiat929 No. Sorry
have fun !the thistle # 667 was my first sailboat. bought her right out of college 1964 .sailed at edgewater yacht club Cleveland Ohio. My 667 was a mahogany plywood boat. If your going to race, weigh the boat before you paint. you might want to just wet sand and not paint 500lb was the light limit back then.....you can put on un needed weight with paint........an ugly boat can be faster than a pretty one o
Very cool! We have sailed at Edgewater at least once a year pretty much my whole life. Small world!
Useless garbage. They just spin in the wall when you try to put the screw in.
We used to race in the Seminole County Sail Fest in Sanford, Florida. There were 700 boats racing on seven courses in the St. John's River. Most were one design classes, including Thistles, Flying Scots and Highlanders. I had raced Flying Scots but had never seen a Highlander or a Thistle. I walked up to an all wood Thistle that looked old. It appeared that the hull was made of laminated mahogany or something like that, no fiberglass, inside or out. I asked the owner about his Thistle, and he said it was hull #1. When we sailed out for one of the races we passed a Thistle that was painted in a tartan pattern, inside and out. My wife, who is of Scottish descent, yelled out, "What's you clan". The immediately responded, "Robertson". The boat was painted with the Robertson tartan. There were probably a dozen Thistles racing and a couple had a large thistle on their spinnakers. They look like fun boats to sail. Good luck with yours.
Thank you!!
I got same one and yes roof screws leaked a little, I went back and caulked over the screws, so far been leak free only had it for about a month
It’s never British though, usually some horrible Scottish or Irish one. Tbh I have a hard time doing an English one for some reason.
I hate you😂😂😂 yes!!!
Nice shed. Do you think it will leak?
I think if it does leak it will be where the screws join the roof pieces. When I get some time I plan on taking some clear silicone clue and possibly dab each roof screw to hopefully prevent that. Specially for the winter.
What is exactly the name of it
Coleman sk100
Thanks 😊
You still have to wear the eclipse glasses even in totality
Cool
Yes it was coll
It was exciting
Hi
Thanks for making this vid I done lost the introductions 🎉
Yes definitely "a little mud on the tires" 😅
Hi, your tractor looks great :-) I have a question - What kind of oil did you use for Kubota? I have B7001 and I have to change before spring.
I used SAE 10w30. I used valvoline brand and not synthetic. Probably can use Synthetic but decided not to since I have not used it on the motor in the past.
Thank you for the help
I get 17.1 to 18 empty
Use a toggle bolt!!!
Mine just keep spinning
Maybe use a larger anchor? Might be worth a try. As a last resort you can try one of the metal ones that expand behind the drywall.
Don’t use airbags yellow sumo springs are better in winter and salt,had air bags lines kept leaking from winter from salt.
Definitely will try, I tried to put Sheer curtain, and the screw You😂, doesn’t Hold The screw I mean The Ceiling. And it’s a pain. I tried to make 2 more Place holes still same result.
Love my 2016 Lariat. I had a 4000lb trailer with 8000lbs of weight on the trailer and it pulled great.
How's the shed holding up?
So far so good! No problems at all.
Then what?
Once the wasps are gone I sprayed the crack with sevine and it got all the hold outs.
Keep it 70 mph, air pressure checked, youll get around 23 mph on highway.
I just got my new 2024 gas and only used half a tank so far and im at 8.6 😢
I have 20k miles on it now. I have never reset my trip B mpg and it’s right at 15.9. I’m thinking that’s my best gauge for my 20k average mpg.
@diamond_industries glad to hear. I'm thinking it gets better as the engine breaks in. I only have 150 miles on it so far. Getting ready to add a smart cap on it this coming week. Mine has the 10 speed so hopefully it gets better mpg's
It’s your driving style. When you hit the gas too much thats what you get
Its the rock on fingers!
Little man hitting everyone with that finger
I got this for my daughter when she was around 18 months old. Very easy to install and take apart to clean! She likes it for the most part and always falls asleep and seems comfortable in it. I love that it will grow with her for a long time.
Hi! Awesome tractor! Did you change the original ag tires? or did it come with those?
These are the original tires. At some point I may get a different pair for the woods and plowing but these have worked for 40 years so why try to reinvent the wheel. Haha
Bs those ones suck too
For sure