Video

U didn’t have to bleed them ?

This vid sux! With a capital SUCK!

Hi how are you? I have a question of hoping you can help me with but first of all thank you for taking the time and making out this video. I have a 2014 Jeep Cherokee trailhawk. I had the local garage flush the transmission fluid they told me they got maybe four quarts out of it. After receiving it back and driving around for 2 days I noticed the transmission temperature is hotter than what it was previous the transmission always stayed around 160 to 165 but after having fluid change I am now 170 to 180 something. How do I know if they put enough fluid in or overfilled it either one can cause the transmission to get hot. Is there something I should worry about with the transmission temperature being higher than before. After putting in new fluid. Thank you

Thank you for this. When i turned my AC on it smelled like something had died. Sure enough, dead mouse in my filter.

Thank you

Thank you sir

2012 xl 6 cylinder. This would also cause poor shifting from the tranny, correct? Not downshifting into second for example when coasting with foot of the gas? Or i need to add tranny fluid

Hello, sir, your video was a lot more helpful than some of the other stuff I found. Only question is what do I look for, just a flexible dip with mm markings then? Thanks in advance

Thank you!

You da man

Did you let out any farts while you were making this?

I aspire to do the 1 handed brake change one day.

Did you check with engine running?

What if it just p2430

Hello! I have the a 2017 accord is the job the same for a 2017. Also same process for the front door? Thank You.

You made it easy. Thank you

Helpful video. I did both rear door lock actuators in 45 minutes total.

I didn't see where your finger touched the reset button come I'm not sure what but you're referring to

Thanks

Perfect 👍

If the truck no start! Can it be the cause

"Turn the Key on" ? I've seen old jalopies with a Starter Button on the floorboard...... "They" used to say, "Mash The Starter".

Do you how it's done on a 2012 CR-Z?

What size is the socket to remove the caliper bracket?

Thank you for this video because I was about to torch this car

The sensor wire unclips from the pad you can leave the entire wire in place.

The piston won’t just push in? I tried it but it didn’t move. The fronts were no problems. Pushed them in with a c clamp. Does this tool turn and push? Thanks

What's the dice of the tool hex bit socket, we need size of tool

thanks brother took you 5 mins and me 2years

🎉Awesome! Thank you so much! Easy quick video!🎉

What about if the door wont open from the inside or out, how can i access the latch when the handles moves on both sides but the lock is stuck in position any suggestions 😅

2013 CRZ and your info does not reset that ugly orange TMS at all. What am I doing wrong ??

I pressed the button nothing happened

Thank you so much. I have been driving around with the tire light on for days even when the problem was resolved

Muchas Gracias 🙏🏼

But the tire itself says 49psi!

Excellent thanks brother 😊

thank you, this was driving me crazy

silo vendes o no

Life saver 🎉❤

Well the procedure is as I expected... But what a royal pain in the grits. Also I was wondering if the dipstick I had would work ... Appreciate the video

Thank you very much

You cracked the left side😮

Thanksssssss

I appreciate you.

Thanks. That did it.

Thank you!

Thank you sir!

Have a 2019 NV 2500 with a rear stuck rotor. Any advice on how to remove it? Did you have to remove the parking brake cable to release the brakes?

Thank you for this video! I've been trying to figure out how to change the time since daylight savings lol