- 7
- 7 138
Philip Cecil
Registrace 8. 07. 2012
A&H Avantis | Outputs
In this video, we will discuss how outputs are routed on our soundboard.
zhlédnutí: 841
Video
A&H Avantis | Building a Mix
zhlédnutí 3,3KPřed 2 měsíci
In this video, we will use what we have learned about input channels to build a mix.
A&H Avantis | Compression
zhlédnutí 329Před 2 měsíci
In this video, we will talk about the parameters for the compressor.
A&H Avantis | Equalizer
zhlédnutí 529Před 2 měsíci
In this video, we will discuss the parameters for EQ.
A&H Avantis | Gate
zhlédnutí 378Před 2 měsíci
In this is video we will talk about how to use a gate on an input channel. Chapters: 0:00 - What is a gate? 0:28 - Attack, Hold, Release, and Threshold 3:54 - Gate on Pastors Mic 4:48 - Gate on a Piano
A&H Avantis | Gain
zhlédnutí 1KPřed 2 měsíci
In this video we go over what is Gain and how to set it. Chapters: 0:00 - What are inputs? 0:46 - What is Gain? 1:34 - How to set Gain 3:47 - 48V/Phantom Power
A&H Avantis | Console Overview
zhlédnutí 775Před 2 měsíci
This video overviews the Allen & Heath Avantis Console for church volunteers. Chapters: 0:00 - Introduction 0:41 - Banks & Layers 2:10 - Strip Assign 3:50 - Layout 7:48 - Master Section 8:09 - Soft Keys
If we put a reverb on a channel can we use the same type of reverb on 10 channels and use different settings on all ten without affecting the other channels Like if I use emt 250 on the snare with 38 ms and .75 ms release And insert that into the snare channel so I don’t have to burn an fix channel just for a snare And then use the same reverb with 38 second pre delay and 1 second of release on over heads with the same type of emt 250 reverb on the overhead channels Am I going to mess up the snare setting or does avantis really let you do individual channel fx Cuz I’m starting to want my fx channels back instead of burning them for just one source
Thanks
Nice ! Thanks
Just learning to run the sound at our church on this same board and this is extremely helpful! EQ especially looked intimidating but your explanation of each topic in each of these videos really helps the viewer, beginners especially, understand them. Thank you!
Nice brother
Great
Thanks for covering the AVANTIS
Cool
Thanks
Nice
Cool
Sir make videos on 2,4,6 element sub patterns.... Main to sub alignment....etc
Hi, is it possible to change the Gate to Expander?
Yes, under the gate library you can swap it out.