Video

Kept a copy to show my roofer what I want.

That’s so smart and nice looking 🔥

Can't see anything doesn't explain anything, typical sheet metal guys

Nice work

I have ramst hammershot and it keeps splitting the 1x3. Any suggestions?

Good nailer, I have the same one

I think wrap the wall 1st. Even if can get by not doing, it just looks better, is more thorough job

Doing God's work👍

No strapping required in the US?

Shiner @6.54

Paper that wall!!!!!

Would heat matter using these aluminum? I live in Texas and get about 110 degrees here

Nice Looks great instead of painting black

What is that white piece on the facia? Just added insurance against water? Looks sweet!

Dude that break is awesome! I’m still using my grandpa’s archaic break but, it’s good to me. Thanks for the tips, keep crushing.

Dang that looks crisp brother! Nice work. Going to start doing that bend too. Thanks

Y quien dijo que se empiece del medio eso pues si no tiene ventana ni llevas trem se empieza en una orilla pongase vergas primo

Se unen las lineas en varios shake

I would like to ask what material is the panel and what material is the vertical bar?

How are you attaching the panel underneath the window where the metal tab has been cut off?

Elite product and installation 🙏👏🏿👍🙌🏾🇺🇸❤️give us more installation education please 🙏

Nice job.

Lmao. Work on your camerawork bud

Pretty cool but one mistake. You should put the piece from the door down the wall first to hide your seem. And you might want to talk and explain what your doing, cause with the camera allnover the place and the no e verbal. I dont really know what you did.

Really awesome job. But dude, you should really use eye protection when using that saw. Wow

What do you use to bend these?

what is the color?

Starting villian arc

Ottawa?

Where can I find this metal fascia? Home Depot only has vinyl

This work is not done to spec by James Hardie and therefor will be out of warranty. 1/4 in gap is needed off flashing and 1/8 in gap is needed off and wood. Also your gaps were inconsistent and your nail placement was questionable.

Do you nail it in?

What adhesive did you use on the cut panel?

That’s one beautiful trick

no explanation, cuts half on half off the center of the screen?

harness but not tied off? :/ #BeSafeAmigo

Did you rip the 4x8 sheet to make board and batton?

Very nice 👍

Is it a 3/4 hymn on the top of that metal or not that usually helps take a wave out of it as well

Hi where I can buy that kind of flashing can’t find t it on home depot or Lowe’s

How did you attach the sill under the window?

You need a little mic or a voiceover ( You seem like a busy guy for a voiceover.), but I bet your content will take off.

Good tool

efficient brake for sure! Better than the Alum A Brake? I seen you used both so thought id ask.

Beautiful!

What brand of snow guard.is that? I am looking to install soe

When you need to get a nail in the wall but you remember you're an American

No way best fascia detail is lp siding as fascia, no bubbling after it expands, no hail dents.

What type of nails/nail gun did you use?

That would be nice if you put tape under the seams