![Kemal Harris](/img/default-banner.jpg)
- 115
- 113 785
Kemal Harris
Registrace 10. 04. 2015
Video
GMC STEPVAN motor and transmission swap
zhlédnutí 44Před 4 měsíci
GMC STEPVAN motor and transmission swap
Hyundai/ Kia steering clunk noise solution
zhlédnutí 57Před 6 měsíci
Hyundai/ Kia steering clunk noise solution
How to reset 2017 Honda Accord oil life
zhlédnutí 161Před 7 měsíci
How to reset 2017 Honda Accord oil life
How to install 2012 Lincoln mkS / Ford power steering pump belt
zhlédnutí 307Před 7 měsíci
How to install 2012 Lincoln mkS / Ford power steering pump belt
Ford f250 fuel pump internal relay by pass
zhlédnutí 794Před rokem
Ford f250 fuel pump internal relay by pass
Nissan Murano (awd) rack and pillion replacement
zhlédnutí 11KPřed rokem
Nissan Murano (awd) rack and pillion replacement
How to remove and reinstall wind shield that leaks
zhlédnutí 20Před rokem
How to remove and reinstall wind shield that leaks
2013 Dodge Grand Caravan head gasket replacement
zhlédnutí 15KPřed rokem
2013 Dodge Grand Caravan head gasket replacement
Cleaning gas tank and install new gas sender unit & pump
zhlédnutí 29Před 2 lety
Cleaning gas tank and install new gas sender unit & pump
2014 Hyundai Santa Fe damaged engine repair
zhlédnutí 230Před 2 lety
2014 Hyundai Santa Fe damaged engine repair
2006 Chrysler 300 crank but won't start (solved)
zhlédnutí 7KPřed 2 lety
2006 Chrysler 300 crank but won't start (solved)
Dodge Ram Pickup 1500 4.7L V8 Engine Rebuild
zhlédnutí 50Před 2 lety
Dodge Ram Pickup 1500 4.7L V8 Engine Rebuild
How to remove and replace rear wheel bearings on 2018 Toyota Camry
zhlédnutí 6KPřed 2 lety
How to remove and replace rear wheel bearings on 2018 Toyota Camry
Staircase complete restoration to modern finishing
zhlédnutí 99Před 2 lety
Staircase complete restoration to modern finishing
What you weld on it Harris?
not good wast of time
I appreciate the attempt but this is the worst repair video I’ve ever seen. No help whatsoever.
No volume or sound!
Im repairing one right now.. hope it starts today.. it was so sad.. and this video sounding like Cristmas
what an absolute waste of internet. loud music, cant hear what youre saying, cant see anything from that camera angle.
That is it.
I have a question do you take the chain off from the side or how is it cause the vedio is not clear enough
didnt take chain off, what i do in most case when replacing head gasket. l would put marks on chain and also the teeth and use zip tie to secure chain so i dont have to re-do the engine timing
czcams.com/video/Td7dGxf46hQ/video.htmlsi=HdqQ5F03dPXT7GVL
czcams.com/video/Td7dGxf46hQ/video.htmlsi=HdqQ5F03dPXT7GVL
czcams.com/video/Td7dGxf46hQ/video.htmlsi=HdqQ5F03dPXT7GVL
czcams.com/video/Td7dGxf46hQ/video.htmlsi=HdqQ5F03dPXT7GVL
czcams.com/video/Td7dGxf46hQ/video.htmlsi=HdqQ5F03dPXT7GVL
czcams.com/video/Td7dGxf46hQ/video.htmlsi=HdqQ5F03dPXT7GVL
czcams.com/video/Td7dGxf46hQ/video.htmlsi=HdqQ5F03dPXT7GVL
Horrible video
Do you have to pull the engine to replace rear head? Is rear called left ir right? Thanks!
no
How do you know was the fuel pump ?
Spray starting fluid in the throttle body then crank up the car if it turns over its the fuel pump 🫱🏾🫲🏽did this with my charger
@@kilosomessyused break cleaner it starts but dies after a second got the fuel pump replaced same thing any help?
Where you located
fort lauderdale florida
Do you need to remove the timing cover for this? I'm repairing the right-hand head? Can I do it without removing the timing cover? Thank you,
What head is rear head? I have to replace on my 14 Caravan 3.6. Thanks
@@SpectrumVans The right hand, the second head, the rear head refer to the one that is changed here. IF you are working on this head, I suggest you remove the engine. It takes 3-5 hours and avoids tons of headache.
Great content
Great content
Great content
How long does it take to change rack & pinion on nissan murano?
👍👍
👏👏👏👏
👍👍👍
What is the name of that tool he used to yank off that part on the wheel?
How did you get the Bank 1 head off without removing the timing cover? Everywhere I look I see that the only way to remove the right head on my 2013 Dodge Grand Caravan 3.6 SXT requires removing the timing cover which subsequently requires removal of the lower oil pan because of the hidden bolts securing the bottom of the cover. It's a pain!
Anyone have the answer to this question? Would be very much appreciated 🙏🏻
I would like to know that too.🙂
Oh my yes please don’t work on cars I just saw what you were doing, very dangerous getting under there with just that Jack and you didn’t have to remove the screws just turn the plastic valve with a screwdriver and it will come out, oh my oh my
Thanks for the videos man, could you please get somebody to hold a camera for you while you do that I’m feeling kind of nauseous now lol
Where's the rest of the video? You just cut it just like that?
Approximately what does a job like this cost thank you.
Over $5k
Not showing any steps
Needs a lot of love but hope too see it hit the road please put up a update video well worth restoring will never build trucks this tough again!!!
Proper Leyland man broke but still grafting RESPECT From Leyland homeland Britain!!!!
Nice too see a great old truck being restored!! Looks like a ex Ready Mix Concrete truck from UK as all there trucks was orange and they had tons of constructors!! Be nice too see a update video!!!!
Drove quite a few of them RMC constructors when they were over ten years old. Nice when new not so when well worn 👍
U in miami...
close, i'm in fort lauderdale
Just out of curiosity, how much does it cost to do that repair?
1. Remove filter and cover. Change the O-ring on the filter cover. Put the filter cartridge into the filter housing cover then screw the cover in. 2. Don't go under car when it's only supported by jack. 3. There's an oil drain plug. You removed the oil level sensor. Use tool VW T10549, available from Snap On for $15, or SDMV1 bit for $11, or equivalent to remove the drain plug. Replace the drain plug. It's identical to that used in the VW Tiguan (and others).
you can change oil on 992 (991 too) without lifting the car. however, you have to be NOT fat, and NOT have short arm.
This is such an honest review😂
You skipping tf out of the how-to 🤣🤣 This your first time making a video bro?
Great explanation
👍🏿👍🏿👍🏿👍🏿
Great VLOG 😊
czcams.com/video/f5Vb86fCgUs/video.html
When I'm ready for something I know who I'm gonna call up on.
I did mine 8hrs
had to take heads to the mashine shop
Hello, Do you need to remove the front of the car. I need to remove #1 head.
Hello, how long did it take for you to do this?
two days
👍👍👍
👍👍👍